=~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2011.03.13 17:22:36 =~=~=~=~=~=~=~=~=~=~=~= Header CRC: 0xA60A6201 Calculate CRC: 0xA60A6201 Image 1 is OK Try to load image 1. Waiting for 5 seconds to upgrade ... CMD: [load -raw -addr=0x806a1900 -max=0xf70000 :] Loader:raw Filesys:tftp Dev:eth0 File:: Options:(null) Loading: _tftpd_open(): retries=0/5 _tftpd_open(): retries=1/5 _tftpd_open(): retries=2/5 _tftpd_open(): retries=3/5 _tftpd_open(): retries=4/5 Failed. Could not load :: Timeout occured CMD: [boot -raw -z -addr=0x80001000 -max=0xf70000 flash0.os:] Loader:raw Filesys:raw Dev:flash0.os File: Options:(null) Loading: .. 3916 bytes read Entry at 0x80001000 Closing network. eth0: cannot clear 1400/00000002 Starting program at 0x80001000 Linux version 2.6.24.111 (unknown@unknown) (gcc version 4.1.2) #3 Sun Mar 13 14:11:29 PDT 2011 CPU revision is: 0002901a Setting the PFC to its default value Determined physical RAM map: memory: 02000000 @ 00000000 (usable) Built 1 zonelists in Zone order. Total pages: 8128 Kernel command line: console=ttyS0,115200 root=1f02 rootfstype=squashfs noinitrd Primary instruction cache 32kB, physically tagged, 4-way, linesize 16 bytes. Primary data cache 32kB, 2-way, linesize 16 bytes. Synthesized TLB refill handler (19 instructions). Synthesized TLB load handler fastpath (31 instructions). Synthesized TLB store handler fastpath (31 instructions). Synthesized TLB modify handler fastpath (30 instructions). PID hash table entries: 128 (order: 7, 512 bytes) CPU: BCM4785 rev 2 at 300 MHz Using 150.000 MHz high precision timer. console [ttyS0] enabled Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) Memory: 27344k/32768k available (3144k kernel code, 5424k reserved, 1479k data, 144k init, 0k highmem) Mount-cache hash table entries: 512 NET: Registered protocol family 16 Generic PHY: Registered new driver PCI: Initializing host PCI: Enabling CardBus PCI: Fixing up bus 0 PCI: Fixing up bridge PCI: Fixing up bus 1 NET: Registered protocol family 2 Time: MIPS clocksource has been installed. IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 1024 (order: 1, 8192 bytes) TCP bind hash table entries: 1024 (order: 0, 4096 bytes) TCP: Hash tables configured (established 1024 bind 1024) TCP reno registered devfs: 2004-01-31 Richard Gooch (rgooch@atnf.csiro.au) devfs: boot_options: 0x1 squashfs: version 3.0 (2006/03/15) Phillip Lougher io scheduler noop registered io scheduler deadline registered (default) HDLC line discipline: version $Revision: 4.8 $, maxframe=4096 N_HDLC line discipline registered. Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled serial8250: ttyS0 at MMIO 0x0 (irq = 8) is a 16550A serial8250: ttyS1 at MMIO 0x0 (irq = 8) is a 16550A PPP generic driver version 2.4.2 PPP Deflate Compression module registered PPP BSD Compression module registered MPPE/MPPC encryption/compression module registered NET: Registered protocol family 24 PPPoL2TP kernel driver, V1.0 tun: Universal TUN/TAP device driver, 1.6 tun: (C) 1999-2004 Max Krasnyansky PCI: Enabling device 0000:01:01.0 (0000 -> 0002) Physically mapped flash: Found 1 x16 devices at 0x0 in 16-bit bank Amd/Fujitsu Extended Query Table at 0x0040 Newer Samsung flash detected, should be compatibile with Amd/Fujitsu. number of CFI chips: 1 cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness. Flash device: 0x800000 at 0x1c000000 bootloader size: 262144 Physically mapped flash: Filesystem type: squashfs, size=0x22d8c7 partition size = 2307072 Creating 5 MTD partitions on "Physically mapped flash": 0x00000000-0x00040000 : "cfe" 0x00040000-0x007f0000 : "linux" 0x0018cc00-0x003c0000 : "rootfs" mtd: partition "rootfs" doesn't start on an erase block boundary -- force read-only 0x007f0000-0x00800000 : "nvram" 0x003c0000-0x007f0000 : "ddwrt" Found a 0MB serial flash sflash: found no supported devices Broadcom Watchdog Timer: 0.07 initialized. u32 classifier Actions configured Netfilter messages via NETLINK v0.30. nf_conntrack version 0.5.0 (1024 buckets, 4096 max) ctnetlink v0.93: registering with nfnetlink. IPv4 over IPv4 tunneling driver GRE over IPv4 tunneling driver ip_tables: (C) 2000-2006 Netfilter Core Team ClusterIP Version 0.8 loaded successfully TCP bic registered TCP cubic registered TCP westwood registered TCP highspeed registered TCP hybla registered TCP htcp registered TCP vegas registered TCP scalable registered NET: Registered protocol family 1 NET: Registered protocol family 17 Welcome to PF_RING 3.2.1 (C) 2004-06 L.Deri NET: Registered protocol family 27 PF_RING: bucket length 128 bytes PF_RING: ring slots 4096 PF_RING: sample rate 1 [1=no sampling] PF_RING: capture TX No [RX only] PF_RING: transparent mode Yes PF_RING initialized correctly. PF_RING: registered /proc/net/pf_ring/ 802.1Q VLAN Support v1.8 Ben Greear All bugs added by David S. Miller decode 1f02 VFS: Mounted root (squashfs filesystem) readonly. Mounted devfs on /dev Freeing unused kernel memory: 144k freed start service starting Architecture code for broadcom Booting device: Linksys WRT300N v1.1 loading bcm57xx loading switch-core loading switch-robo roboswitch: Probing device eth0: <3>roboswitch: [drivers/net/switch/switch-robo.c:126] SIOCGETCPHYRD failed! roboswitch: [drivers/net/switch/switch-robo.c:126] SIOCGETCPHYRD failed! No Robo switch in managed mode found, phy_id = 0xffffffff roboswitch: Probing device eth1: found! sh: can't create /proc/switch/eth0/reset: nonexistent directory /etc/preinit: line 66: can't create /proc/sys/net/ipv4/ip_conntrack_max: nonexistent directory /etc/preinit: line 66: can't create /proc/sys/net/ipv4/ip_conntrack_max: nonexistent directory eth0: Operation not supported wl0.3: No such device nbw = 20 eth0: Operation not supported eth0: Operation not supported eth0: Operation not supported eth0: Operation not supported eth0: Invalid argument eth0: Invalid argument br1: Dropping NETIF_F_UFO since no NETIF_F_HW_CSUM feature. br1: starting userspace STP failed, starting kernel STP Algorithmics/MIPS FPU Emulator v1.5 br2: Dropping NETIF_F_UFO since no NETIF_F_HW_CSUM feature. br2: starting userspace STP failed, starting kernel STP sh: can't create /proc/sys/net/bridge/bridge-nf-call-arptables: nonexistent directory sh: can't create /proc/sys/net/bridge/bridge-nf-call-ip6tables: nonexistent directory sh: can't create /proc/sys/net/bridge/bridge-nf-call-iptables: nonexistent directory br0: Dropping NETIF_F_UFO since no NETIF_F_HW_CSUM feature. device br0 entered promiscuous mode br0: Bad file descriptor device vlan0 entered promiscuous mode device eth1 entered promiscuous mode br0: Bad file descriptor eth0: Operation not supported wl0.3: No such device nbw = 20 eth0: Operation not supported eth0: Operation not supported eth0: Operation not supported eth0: Operation not supported eth0: Invalid argument eth0: Invalid argument device eth0 entered promiscuous mode device wl0.1 entered promiscuous mode br1: port 1(wl0.1) entering listening state device wl0.2 entered promiscuous mode br2: port 1(wl0.2) entering listening state br0: port 2(eth0) entering learning state br0: port 1(vlan0) entering learning state device br0 left promiscuous mode device br0 entered promiscuous mode device br0 left promiscuous mode device br0 entered promiscuous mode br1: port 1(wl0.1) entering learning state br2: port 1(wl0.2) entering learning state br0: topology change detected, propagating br0: port 2(eth0) entering forwarding state br0: topology change detected, propagating br0: port 1(vlan0) entering forwarding state br1: port 1(wl0.1) entering disabled state br1: port 1(wl0.1) entering listening state device wl0.1 is already a member of a bridge; can't enslave it to bridge br1. SIOCGIFFLAGS: No such device br2: port 1(wl0.2) entering disabled state br2: port 1(wl0.2) entering listening state device wl0.2 is already a member of a bridge; can't enslave it to bridge br2. SIOCGIFFLAGS: No such device device vlan1 entered promiscuous mode SIOCGIFFLAGS: No such device device vlan1 left promiscuous mode device wl0.1 is not a slave of br0 device wl0.2 is not a slave of br0 SIOCGIFFLAGS: No such device device vlan0 left promiscuous mode br0: port 1(vlan0) entering disabled state device eth0 left promiscuous mode br0: port 2(eth0) entering disabled state bridge br0 is still up; can't delete it br1: port 1(wl0.1) entering learning state br2: port 1(wl0.2) entering learning state sh: can't create /proc/sys/net/bridge/bridge-nf-call-arptables: nonexistent directory sh: can't create /proc/sys/net/bridge/bridge-nf-call-ip6tables: nonexistent directory sh: can't create /proc/sys/net/bridge/bridge-nf-call-iptables: nonexistent directory br1: topology change detected, propagating br1: port 1(wl0.1) entering forwarding state br2: topology change detected, propagating br2: port 1(wl0.2) entering forwarding state unregister_netdevice: waiting for eth1 to become free. Usage count = 1 unregister_netdevice: waiting for eth1 to become free. Usage count = 1 unregister_netdevice: waiting for eth1 to become free. Usage count = 1 Start to blink diag led ...