Author | Message |
---|---|
Topic: SOLVED Non DD-WRT -- Deliberant APC 5M - Country legislati | |
npaisnel Replies: 0 Views: 1825 |
Forum: General Questions Posted: Thu Mar 26, 2015 8:18 Subject: SOLVED Non DD-WRT -- Deliberant APC 5M - Country legislati |
EDIT:
If any one else comes across this with a Deliberant Router, and needs to ramp up the power a bit for testing etc then since version v 5.78 firmware they added a Compliance testing mode that dis ... |
|
Topic: Disabling Regulatory Domain | |
npaisnel Replies: 15 Views: 61622 |
Forum: Atheros WiSOC based Hardware Posted: Wed Mar 04, 2015 18:16 Subject: Disabling Regulatory Domain |
I just stopped mucking around in the end and bought Deliberant kit
APC-5M-90, SECTOR ANTENNA unit and two APC-5M-18's for the other end to make a Point to MultiPoint setup I got a single DIR-3 ... |
|
Topic: Power supply for D-Link DIR 300 | |
npaisnel Replies: 7 Views: 12433 |
Forum: Hardware DIY / Hardware Mods Posted: Thu Feb 19, 2015 7:01 Subject: Power supply for D-Link DIR 300 |
Hi
Thanks, yes good advice I did chrck the input cap voltage specs and they were I believe over spec'd in that department. Seem to remember 50 or 63volt spec. I had 4 of these DIR-300, and di ... |
|
Topic: New equipment for low bandwidth 500 meter bridge | |
npaisnel Replies: 4 Views: 3253 |
Forum: General Questions Posted: Mon Feb 16, 2015 9:53 Subject: New equipment for low bandwidth 500 meter bridge |
Great, thanks for the tip. I get you now.
I had thought of this set up...I want to go Single Ap to Multi point clients networks, both less the 40 degrees apart I see the Rocket M5, and also o ... |
|
Topic: New equipment for low bandwidth 500 meter bridge | |
npaisnel Replies: 4 Views: 3253 |
Forum: General Questions Posted: Mon Feb 09, 2015 13:30 Subject: New equipment for low bandwidth 500 meter bridge |
OK, thanks
so you think external antennas are no better than the built in ones? |
|
Topic: New equipment for low bandwidth 500 meter bridge | |
npaisnel Replies: 4 Views: 3253 |
Forum: General Questions Posted: Mon Feb 09, 2015 10:42 Subject: New equipment for low bandwidth 500 meter bridge |
Quick question then further info below.
I need to go out and buy a pair of routers to act as a bridge, but no idea what to buy. Needs are 600 meter low bandwidth bridge (Not talking streaming Netf ... |
|
Topic: Disabling Regulatory Domain | |
npaisnel Replies: 15 Views: 61622 |
Forum: Atheros WiSOC based Hardware Posted: Mon Feb 09, 2015 8:33 Subject: Disabling Regulatory Domain |
I would forget bridge mode and just use Client mode. Leave the first on AP and set the second to Client. If you're connected to the Client router wirelessly, don't forget to set up a virtual acc ... |
|
Topic: Disabling Regulatory Domain | |
npaisnel Replies: 15 Views: 61622 |
Forum: Atheros WiSOC based Hardware Posted: Sun Feb 08, 2015 17:10 Subject: Disabling Regulatory Domain |
Thanks, good to know.
I don't have great distance, 600 meters a most. I did all this a few years ago, but only had one dd-wrt firmware router. I now have two atheros, DIR 300's have them ... |
|
Topic: Power supply for D-Link DIR 300 | |
npaisnel Replies: 7 Views: 12433 |
Forum: Hardware DIY / Hardware Mods Posted: Sun Feb 08, 2015 14:37 Subject: Power supply for D-Link DIR 300 |
Well a open circuit 7.5 volt unit was putting out 9.5 volt.
under load from the DIR 300 it dropped to 8 volts and has been running for 10 minutes or more now..not let the smoke out yet. |
|
Topic: Power supply for D-Link DIR 300 | |
npaisnel Replies: 7 Views: 12433 |
Forum: Hardware DIY / Hardware Mods Posted: Sun Feb 08, 2015 13:51 Subject: Power supply for D-Link DIR 300 |
Oh, well
I never used the DIR-300 as I never found a PSU. I had forgotten about this thread...my search just brought it up when I was wondering the same thing all most three years later. Well I ... |
|
Topic: Disabling Regulatory Domain | |
npaisnel Replies: 15 Views: 61622 |
Forum: Atheros WiSOC based Hardware Posted: Sun Feb 08, 2015 13:23 Subject: Disabling Regulatory Domain |
i hate to repeat myself but as is state read you hw specs! if the amp cant do more your out of luck. so buy better hw!
OK, so this is an old thread, but still valid. Assuming we have now read ou ... |
|
Topic: DIR 300 Rev A or B for bridge? with WRT54G | |
npaisnel Replies: 0 Views: 1635 |
Forum: Atheros WiSOC based Hardware Posted: Fri Feb 06, 2015 14:51 Subject: DIR 300 Rev A or B for bridge? with WRT54G |
Question here form an 'old' newbie. since I last did anything with dd-wrt it has all worked fine, and invisibly and I have forgotten all I did last time
Question: Can the Rev A1 be setup as Cli ... |
|
Topic: ack timing - Lets clear this up | |
npaisnel Replies: 10 Views: 75122 |
Forum: Broadcom SoC based Hardware Posted: Tue Jun 19, 2012 20:25 Subject: ack timing - Lets clear this up |
You will get very little help here, this is not like some forums, you really just have to use the wiki, and that is about it..just look at the number of unanswered posts.
The guys that do the work ... |
|
Topic: CB mode with DIR-300A and Firmware 18000? | |
npaisnel Replies: 1 Views: 1797 |
Forum: Atheros WiSOC based Hardware Posted: Thu May 10, 2012 12:12 Subject: CB mode with DIR-300A and Firmware 18000? |
Does anyone know if CB mode works with a DIR-300 A with 18000 firmware?
I have CB mode working with a WRT54G, connecting to the same access point, Also previously connected a DIR 300 Rev B rout ... |
|
Topic: easiest way to hide lan computers from wireless computers | |
npaisnel Replies: 6 Views: 4838 |
Forum: Broadcom SoC based Hardware Posted: Mon Apr 30, 2012 8:56 Subject: easiest way to hide lan computers from wireless computers |
As Insaid in my first reply, I am novice at this too
Maybe my understanding of what bridge does and does not do is flawe'd May be try a hard reset 30/30/30 and setup again? |
|
All times are GMT |