WRT1900ACv1, 20C Higher CPU Temps w/r31571

Post new topic   Reply to topic    DD-WRT Forum Index -> Marvell MVEBU based Hardware (WRT1900AC etc.)
Author Message
Kasm279
DD-WRT Novice


Joined: 14 Feb 2014
Posts: 29

PostPosted: Sat Mar 25, 2017 17:33    Post subject: WRT1900ACv1, 20C Higher CPU Temps w/r31571 Reply with quote
Did the offsets change between r28628 and r31571? I've been noticing consistent twenty degree higher CPU tempuratures since moving to the newer build. WL0 and WL1 temps are the usual 60C, but the CPU is now staying around 75-80C instead of its previous 65C.
Sponsor
myersw
DD-WRT Guru


Joined: 13 Jun 2006
Posts: 1608
Location: SE Michigan USA

PostPosted: Sat Mar 25, 2017 18:25    Post subject: Reply with quote
When I used my wrt1900ac v1 it normally was around 75 to 80 degrees with the newer builds. These are not temps to worry about. Linksys sets the fan on the wrt1900ac v1 to come on at 85 and off at 80 degrees. That is what I always set the dd-wrt firmware to, not the default of 65 on and 60 off. Setting are found in services tab. These cpu's can take high temps without issue.
Currently running a wrt1900acs v1 with latest Brainslayer.
--bill

_________________
Unifi Security Gateway: Unifi Firmware
Netgear r7800: Voxel Firmware
Modem:Netgear CM500V voice and Data.
ISP:Comcast
tutorial for flashing "WRT" series:
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=287813
DD-WRT Installation, Upgrade & Basic Setup–Cliff Notes:
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=311117
Kong DD-WRT Config Tutorial:
http://www.instructables.com/id/Install-and-Configure-a-DD-WRT-Kong-Router/
I tried to be normal once. Worst 2 minutes ever.
Kasm279
DD-WRT Novice


Joined: 14 Feb 2014
Posts: 29

PostPosted: Sat Mar 25, 2017 18:53    Post subject: Reply with quote
So do you think it was just an offset thing? I wasn't worried about the temperature itself, just the drastic change.
Yemble
DD-WRT Guru


Joined: 17 Feb 2010
Posts: 611
Location: Yorkshire (GOC)

PostPosted: Sat Mar 25, 2017 20:58    Post subject: Re: WRT1900ACv1, 20C Higher CPU Temps w/r31571 Reply with quote
Kasm279 wrote:
Did the offsets change between r28628 and r31571? I've been noticing consistent twenty degree higher CPU tempuratures since moving to the newer build. WL0 and WL1 temps are the usual 60C, but the CPU is now staying around 75-80C instead of its previous 65C.


Yes, it seems to be out by around 15C. I have compensated by lowering the fan thresholds to 50C/45C. Temp is now holding below 65C as before.

Note that the fan becomes audible until the "new" cooling temperature (below 65C) has been attained, then it is silent once more.
myersw
DD-WRT Guru


Joined: 13 Jun 2006
Posts: 1608
Location: SE Michigan USA

PostPosted: Sun Mar 26, 2017 19:45    Post subject: Reply with quote
My temps are about the same across builds and also firmware, LEDE and Gargoyle as well as DD-WRT

Running latest Gargoyle currently and here are my temps:
CPU Temperature:77 °C
RAM Temperature:47 °C
Wifi Temperature:46 °C

--bill

_________________
Unifi Security Gateway: Unifi Firmware
Netgear r7800: Voxel Firmware
Modem:Netgear CM500V voice and Data.
ISP:Comcast
tutorial for flashing "WRT" series:
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=287813
DD-WRT Installation, Upgrade & Basic Setup–Cliff Notes:
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=311117
Kong DD-WRT Config Tutorial:
http://www.instructables.com/id/Install-and-Configure-a-DD-WRT-Kong-Router/
I tried to be normal once. Worst 2 minutes ever.
Display posts from previous:    Page 1 of 1
Post new topic   Reply to topic    DD-WRT Forum Index -> Marvell MVEBU based Hardware (WRT1900AC etc.) All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum