can't find EA6350 jtag pint out

Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Broadcom SoC based Hardware
Author Message
andykpng
DD-WRT Novice


Joined: 08 Dec 2012
Posts: 2

PostPosted: Mon Jun 19, 2017 2:52    Post subject: can't find EA6350 jtag pint out Reply with quote
my ea6350 is completely bricked because I accidentally erase nflash0 in CFE. The only ways to recover this should be jtag now(or maybe there is some way to boot in to nflash1?). But I couldn't locate the jtag pin out on the motherboard. There aren't any infomation on the web for this. There are 3 10-pin connector. I used my multimeter to test them, J6 seems to be Jtag but I'm not quite sure about it. Anyone know exactly where is the Jtag connector located on EA6350 board?

Thanks a lot!!
Sponsor
Malachi
DD-WRT Guru


Joined: 17 Jul 2012
Posts: 5451
Location: Columbus, Ohio

PostPosted: Mon Jun 19, 2017 9:00    Post subject: Reply with quote
Please make the picture smaller. I'm pretty sure jtag doesn't support the chip.
_________________
I am far from a guru, I'm barely a novice.
andykpng
DD-WRT Novice


Joined: 08 Dec 2012
Posts: 2

PostPosted: Mon Jun 19, 2017 12:46    Post subject: Reply with quote
Malachi wrote:
Please make the picture smaller. I'm pretty sure jtag doesn't support the chip.


oh.. that means the router is garbage now unless I'd got the device to flash the nand..
well, thanks anyway
Display posts from previous:    Page 1 of 1
Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Broadcom SoC based Hardware All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You can attach files in this forum
You can download files in this forum