Hi,
Today I installed two tl-wa7510n and they work well!
I have only one question, there is a channel that works better than the other at a distance of 1km?
Thanks!
Mirco
Hi,
Today I installed two tl-wa7510n and they work well!
I have only one question, there is a channel that works better than the other at a distance of 1km?
Thanks!
Mirco
An antenna is set as an access point and the other as client bridge.
I chose channel 100 .
The distance is about 1km then I set ack = 2000
tx power = 80dbm
Short preamble = enable
Is there anything else to be set to improve the quality of the signal?
Why in the "wireless packet info" of the client bridge there are a lot of errors in RX ?
Thanks.
Mirco
Hi,
I bought this unit for cheap. Factory FW is poor so I flashed latest DD-WRT v3.0-r32170 std and it is functioning flawlessly. However I am unable to set correct TX/RX antenna chain for use with an external antenna. Only in-build vertical antenna is working.
Any chance of future support for correct RX/TX chains? Or is there some other way to change it?