[mikeregister]

I am attempting to setup the guest network on my WRT3200ACM to route through my VPN (PIA) while having access directly to the ISP on the other network.

I have followed a couple different tutorials and am able to connect, but get no internet connection on the guest network once connected.

I started out by using the instructions on PIA's website:
DD-WRT OPENVPN (OLDER BUILDS) SETUP

Then I followed these instructions from FlashRouter:
How To Setup a DD-WRT Guest Wireless Network On Your FlashRouter
How do I setup a DD-WRT VPN Guest Network?

Does anyone have any advice or anything I might be missing to get this to work properly? I do not have a router directly from FlashRouters, just using their instructions.

My router is currently running 33257.

[mikeregister]

I went ahead and upgraded to the latest build (33342) and factory reset the router and started over. This time I used the settings from here to put my VPN on the router:

Private Internet Access (PIA) OpenVPN (Strong Encryption) DD-WRT Router Setup Guide

My regular SSID (ath1) connected to the ISP should be on 192.168.1.100-150

My VPN SSID (ath1.1) should be on 192.168.12.100-150

Everything works fine on both SSIDs (with VPN working on both) until I enter the Policy Based Routing Info of:

192.168.12.100/30
192.168.12.104/29
192.168.12.112/28
192.168.12.128/28
192.168.12.144/30
192.168.12.148/31
192.168.12.150/32

Once I enter that info in Policy Based Routing, the network that is not supposed to have VPN doesn't, but the one that is supposed to have VPN doesn't have internet access. I have noticed a couple times that I could get "page cannot be displayed" and it would refresh and load the page, not sure how that happens...

Any ideas? Am I doing something wrong or is this a bug with the firmware?

[reforo]

Hi, I only have 2 policies and it works for me

[aventus]

@mikeregister

Deactivate sfe

[mikeregister]