[v2k]

That's the title of my 192.168.1.1 page

- what device you are using exactly (brand, type, revision);
WRT350N v?

- the exact DD-WRT version used (version number, build date);
Firmware: DD-WRT v24 Beta (08/15/07) mini

- a short description of what you were trying to do;
Get wireless connection working.

- a short report of what happened;
was working, seems to have stopped recently, but I was always seeing "Error" on the router's page


on http://192.168.1.1/
Under Wireless Radio it reads: Error

I cannot access any other pages. I've powered on/off the router, but nothing changes.


Under Wireless Packet Info:
Received (RX)52 OK, no error
Transmitted (TX)288 OK, 1116 errors

[Rekoil]

Hold the reset button for 30 seconds to reset settings. That'll get rid of the WRT350N- Error title, should fix the wireless too.

[v2k]

ack, I should have tried that first.

thanks, that worked.

[v2k]

Looks like I'm still having troubles. I was trying to add some MAC settings when it crashed, so I reset it; re-loaded my settings; but now wireless isn't working. It's not broadcasting the SSID, although it says everything is fine:


Wireless Packet Info
Received (RX)
100%
0 OK, no error
Transmitted (TX)
100%
0 OK, no error

[v2k]

I notced that under: http://192.168.1.1/Wireless_Basic.asp

Most of the settings were gone; I had to reset it and redo all my settings yet again, as for some reason the saved bin I'd made did not contain the enable SSID setting, along with some others.

[Rekoil]

Don't restore settings that you'd saved from an earlier or maybe even the problematic setup. Reset again and do it all manually.

[v2k]

I'm having connectivity issues. The signals to my 360 and laptop are about 63% at a distance of about 12ft. Next to the router, the laptop gets up to 75%.

I tried B-Only to try and improve it, but it's the same. I followed the FAQ in trying different channels, but the laptop keeps disconnecting. I didn't have these problems with the WRT54GS which I am replacing.

RadioRadio is On ModeAP
NetworkB-Only
Channel1
Xmit84 mW
Rate11 Mbps
Encryption - Interface wl0Enabled, WPA
Personal PPTP StatusDisconnected

Any tips?

[v2k]

I'm still getting a lot of errors and frequent disconnects.

[v2k]

I flashed up to the v24 RC3 std; tried G-Only... tried changing channels, Xmit set to 84 mW

Laptop right next to router is getting signal of ~68% and drops every 10 minutes or so.

What's going on?