I have it up and runnng and can access via http and telnet.
I have read the wiki but can't resolve the following issue:
Trying to set up OSLR but things don't seem to be going too well.
The wiki tells me that RSSI: 0 dBm noise: 0 dBm is not correct.
I also do not have my WLAN IP and Netmask showing at eth1, even though I have it set under wireless>IP address/subnet mask
I have tried following the instruction onm the WIKI (v.24 Final Broadcom) with no success. My build is later than 9503
Any thoughts on what to do? I have probably missed something somewhere :-(
Joined: 13 Nov 2008 Posts: 5266 Location: CENTRAL Midnowhere
Posted: Mon Nov 17, 2008 2:45 Post subject:
Someone who knows something about mesh networks will have to help, but geez, louise!....any chance that problems could be due to the age of the build....versions are up to 10923 now...
Joined: 13 Nov 2008 Posts: 5266 Location: CENTRAL Midnowhere
Posted: Mon Nov 17, 2008 3:26 Post subject:
Were there cobwebs on it?
Link to the path to the newer builds is given in the Peacock thread. Worth a read. It's a sticky at the top of the first page of the forum. (You just need to look at the first two posts).
Joined: 13 Nov 2008 Posts: 5266 Location: CENTRAL Midnowhere
Posted: Mon Nov 17, 2008 4:22 Post subject:
It means NEW DRIVER...which is, as I understand it, the new wireless driver as opposed to the Vintage driver. The vintage driver is for the old wrt54g and wrt54gs routers (but not for the wrt54g2 which are not the same as the wrt54g v.2 ).
For a linksys wrt54gl, you should use the NEWD driver.
OK - finally got it upgraded. However, it won't let me login via telnet to check the settings. I can log into the web interface perfectly, but not using telnet. I could before the upgrade. Any thoughts?
Since the upgrade the IP now shows up correctly in eth1, but wl status still shows: