Posted: Sun Jun 13, 2010 22:07 Post subject: RSPRO Site Survey
Hi,
I am running 14473
Using an R2N on Channel 13 works fine until i run a site survey. After the site survey has run. It changes to Channel 1. I then have to go select another channel other than 13, then go back to 13.
I understand that doing a site survey must make it sweep all channels but it does not seem to return to the original channel.
Joined: 06 Jun 2006 Posts: 7492 Location: Dresden, Germany
Posted: Mon Jun 14, 2010 17:22 Post subject:
signals might change after first seconds up to 3 minutes since calibration of the radio is still running. this is a normal behaviour. this will especially happen in warmup phase if the cards are still in cold condition _________________ "So you tried to use the computer and it started smoking? Sounds like a Mac to me.." - Louis Rossmann https://www.youtube.com/watch?v=eL_5YDRWqGE&t=60s