[frogm4n]

I use DD-WRT v24-sp2 (08/07/10)build 14896, everything seems OK until I reboot the unit. My wireless security setting on nvram not loading on booting, after I click apply setting on wireless -> wireless security tab security setting turn on again.
this is the capture of iwconfig=
before:
ath0 IEEE 802.11ng ESSID:"telkom.wpa"
Mode:Master Frequency:2.462 GHz Access Point: 00:25:9C:49:EC:6A
Bit Rate:0 kb/s Tx-Power=20 dBm Sensitivity=0/3
Retry:off RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality=0/94 Signal level=-256 dBm Noise level=-96 dBm
Rx invalid nwid:53 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0

after:
ath0 IEEE 802.11ng ESSID:"telkom.wpa"
Mode:Master Frequency:2.462 GHz Access Point: 00:25:9C:49:EC:6A
Bit Rate:0 kb/s Tx-Power=20 dBm Sensitivity=0/3
Retry:off RTS thr:off Fragment thr:off
Encryption key:F3E7-3817-3D68-EF0C-73B1-ED86-0DC4-6EFD [2] Security mode:open
Power Management:off
Link Quality=0/94 Signal level=-256 dBm Noise level=-94 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0

you can see if the encryptio turn off before clickiing apply setting.
anyone with the same problem? some help please

[Sash]

upgrade first

[frogm4n]

already trying 14929, 15704 and the latest verison 15778. not work at all.
finaly back to 14896 official version from supported device database. solve by poorman method:
- enabling jffs support
- cp /tmp/ath0_hostap.conf /jffs/etc/config
- make startup script+
sleep 30
hostapd -B /jffs/etc/config/ath0_hostap.conf

not best solution but it's work