[LatinUnit]

-DIR-516 D2 LATEST FIRMWARE:DD-WRT v24-sp2 (11/21/10) std (SVN revision 15778)
-DWA-140 USB DONGLE WIRELESS-N LATEST DRIVERS

Hi, id like to change the channel width via telnet anyone know the command?

I've played with the following commands but no luck

Usage: iwlist [interface] scanning [essid NNN] [last]
[interface] frequency
[interface] channel
[interface] bitrate
[interface] rate
[interface] encryption
[interface] keys
[interface] power
[interface] txpower
[interface] retry
[interface] ap
[interface] accesspoints
[interface] peers
[interface] event
[interface] auth
[interface] wpakeys
[interface] genie
[interface] modulation

iwconfig

ra0 RTWIFI SoftAP ESSID:"LATINUNIT" Nickname:""
Mode:Managed Channel=5 Access Point: 1C:AF:F7:AA:49:48
Bit Rate=300 Mb/s

Problem is im getting 144.4Mbps out of 270Mbps and i have spent the past 14 hours trying all kinds of settings but it just wont work, so how can i read the channel width value in telnet and also change it to 40Mhz as the internet page doesnt seem to change it.



1-Tried N-only NG, Mixed.
2- Tried changing MIMO settings to 270
3-Enabling disabling QoS,WMM, Afterburn etc etc
4.All possible kinds of modes

[Peabody]

See the first post in this forum, and the wiki article on how to configure N properly.

[LatinUnit]

My Question still is, how to see the current channel width value via telnet and how to change it VIA TELNET. not how to configure an N-wireless router. However thank you for ur interest

[Sash]

btw WPA Algorithms is wrong on N

[Jorge Silva]

available chanels for N mode are 1 ; 6 ; 11 , other wise it won't work, like Peabody said just follow the wiki page.

Regards,
Jorge Silva