Problem is im getting 144.4Mbps out of 270Mbps and i have spent the past 14 hours trying all kinds of settings but it just wont work, so how can i read the channel width value in telnet and also change it to 40Mhz as the internet page doesnt seem to change it.
1-Tried N-only NG, Mixed.
2- Tried changing MIMO settings to 270
3-Enabling disabling QoS,WMM, Afterburn etc etc
4.All possible kinds of modes
See the first post in this forum, and the wiki article on how to configure N properly. _________________ I fix "shortcuts". If you don't have time to read thoroughly, I don't have time to re-type what you missed.
My Question still is, how to see the current channel width value via telnet and how to change it VIA TELNET. not how to configure an N-wireless router. However thank you for ur interest