Linksys/Cisco E2500 for DD-WRT

Post new topic   Reply to topic    DD-WRT Forum Index -> Broadcom SoC based Hardware
Author Message
Fractal
DD-WRT Guru


Joined: 19 Apr 2010
Posts: 1243

PostPosted: Tue May 03, 2011 15:03    Post subject: Linksys/Cisco E2500 for DD-WRT Reply with quote
I have been doing some testing with the E2500 unit... I think the port is going to be pretty easy. I will attach some output dumps from the e2500 that I conducted during my testing.... Today I noticed that walmart/staples/officedepot are no longer carrying the E2K/E3K/ and are moving to the E1500/1700/2500/4200. So porting to E2500 is not a bad idea...
Code:

#
# dmesg
# cat /proc/cpuinfo 
system type      : Broadcom BCM5357 chip rev 1
processor      : 0
cpu model      : MIPS 74K V4.9
BogoMIPS      : 149.50
wait instruction   : no
microsecond timers   : yes
tlb_entries      : 64
extra interrupt vector   : no
hardware watchpoint   : yes
ASEs implemented   : mips16 dsp
VCED exceptions      : not available
VCEI exceptions      : not available

unaligned_instructions   : 40
dcache hits      : 2147483648
dcache misses      : 736174114
icache hits      : 2147483648
icache misses      : 3757207204
instructions      : 2147483648


CFE BOOT:

Code:

Boot version: v4.12
The boot is CFE
Nothing...
No country code find

### CLKDIV= 0x20e0842, SFlashClkDiv=2 clkdivsf=2 ###

### Change it to 0x20e0842 (2) ###
Device eth0:  hwaddr C0-C1-C0-XX-XX-XX, ipaddr 192.168.1.1, mask 255.255.255.0
        gateway not set, nameserver not set
  Header CRC:    0xBEAC3156
  Calculate CRC: 0xBEAC3156


internal pic as well:



Last edited by Fractal on Tue May 03, 2011 15:13; edited 1 time in total
Sponsor
Dark_Shadow
DD-WRT Guru


Joined: 31 Aug 2009
Posts: 2448
Location: Third Rock from the Sun

PostPosted: Tue May 03, 2011 15:11    Post subject: Reply with quote
Any internal pics?
_________________
Peacock Thread-FAQ -- dd-wrt Wiki

Testing Multiple Routers -- Bootloader Collection Project -- My Wiki
Fractal
DD-WRT Guru


Joined: 19 Apr 2010
Posts: 1243

PostPosted: Tue May 03, 2011 15:13    Post subject: Reply with quote
updated with pic...

Fractal
Fractal
DD-WRT Guru


Joined: 19 Apr 2010
Posts: 1243

PostPosted: Tue May 03, 2011 15:16    Post subject: Reply with quote
Getting closer:

Code:

Linux version 2.6.22-g28ac0946-dirty (root@GavinPC.localdomain) (gcc version 4.2.3) #339 Wed Feb 23 20:27:27 CST 2011
CPU revision is: 00019749
Found a 8MB ST compatible serial flash
wombo_reset set to gpio 23
Determined physical RAM map:
 memory: 04000000 @ 00000000 (usable)
User-defined physical RAM map:
 memory: 04000000 @ 00000000 (usable)
Zone PFN ranges:
  Normal          0 ->    16384
  HighMem     16384 ->    16384
early_node_map[1] active PFN ranges
    0:        0 ->    16384
Built 1 zonelists.  Total pages: 16384
Kernel command line: root=/dev/mtdblock2 console=ttyS0,115200 init=/sbin/preinit mem=64M
Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, linesize 32 bytes.
Synthesized TLB refill handler (20 instructions).
Synthesized TLB load handler fastpath (32 instructions).
Synthesized TLB store handler fastpath (32 instructions).
Synthesized TLB modify handler fastpath (31 instructions).
PID hash table entries: 512 (order: 9, 2048 bytes)
CPU: BCM5357 rev 1 at 300 MHz
Using 150.000 MHz high precision timer.
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 60428k/65536k available (2705k kernel code, 5048k reserved, 522k data, 208k init, 0k highmem)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
PCI: no core
PCI: Fixing up bus 0
NET: Registered protocol family 2
Time: MIPS clocksource has been installed.
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
gpio_init: power pulse time 7
Register DIAG LED in /proc/sys/diag_blink.
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
squashfs: version 3.2-r2 (2007/01/15) Phillip Lougher
fuse init (API version 7.8)
io scheduler noop registered (default)
HDLC line discipline: version $Revision: 1.1.1.1 $, maxframe=4096
N_HDLC line discipline registered.
Serial: 8250/16550 driver $Revision: 1.1.1.1 $ 4 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0x0 (irq = 8) is a 16550A
loop: module loaded
PPP generic driver version 2.4.2
NET: Registered protocol family 24
pflash: found no supported devices
sflash: squash filesystem with lzma found at block 1706
Creating 4 MTD partitions on "sflash":
0x00000000-0x00040000 : "boot"
0x00040000-0x007f0000 : "linux"
0x001aaa24-0x007f0000 : "rootfs"
mtd: partition "rootfs" doesn't start on an erase block boundary -- force read-only
0x007f0000-0x00800000 : "nvram"
u32 classifier
nf_conntrack version 0.5.0 (512 buckets, 4096 max)
edward ====to register conntrack protocol helper for esp:
nf_conntrack_rtsp v0.6.21 loading
GRE over IPv4 tunneling driver
nf_nat_rtsp v0.6.21 loading
edward =======nf_nat_proto_esp_init
ip_tables: (C) 2000-2006 Netfilter Core Team
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 10
ip6_tables: (C) 2000-2006 Netfilter Core Team
IPv6 over IPv4 tunneling driver
NET: Registered protocol family 17
Ebtables v2.0 registered
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (squashfs filesystem) readonly.
Freeing unused kernel memory: 208k freed
Dark_Shadow
DD-WRT Guru


Joined: 31 Aug 2009
Posts: 2448
Location: Third Rock from the Sun

PostPosted: Tue May 03, 2011 15:26    Post subject: Reply with quote
Can't really read the chip numbers, can you post'em?
_________________
Peacock Thread-FAQ -- dd-wrt Wiki

Testing Multiple Routers -- Bootloader Collection Project -- My Wiki
Fractal
DD-WRT Guru


Joined: 19 Apr 2010
Posts: 1243

PostPosted: Tue May 03, 2011 15:46    Post subject: Reply with quote
Chips:

Wireless Radio = BCM5358U (2.4ghz)
Wireless Radio = BCM43236 (5.8ghz)
matthileo
DD-WRT Novice


Joined: 30 May 2011
Posts: 3

PostPosted: Mon May 30, 2011 19:46    Post subject: Reply with quote
Any word on how this is going?
jaksco
DD-WRT Novice


Joined: 12 Jun 2011
Posts: 3

PostPosted: Sun Jun 12, 2011 19:17    Post subject: Reply with quote
Any development? Very Happy
sektor
DD-WRT Novice


Joined: 25 Dec 2006
Posts: 2
Location: Florida

PostPosted: Tue Jun 28, 2011 22:15    Post subject: E2500 updates Reply with quote
Any updates on possible firmware?
doublej472
DD-WRT Novice


Joined: 29 Jun 2011
Posts: 2

PostPosted: Wed Jun 29, 2011 18:17    Post subject: E2500 router Reply with quote
How much of the software has been done so far?
Fractal
DD-WRT Guru


Joined: 19 Apr 2010
Posts: 1243

PostPosted: Wed Jun 29, 2011 19:44    Post subject: Re: E2500 router Reply with quote
The CFE has been dumped and are just awaiting eko's response... The CFE dumped info is in this thread.

Fractal

http://www.dd-wrt.com/phpBB2/viewtopic.php?t=140536

doublej472 wrote:
How much of the software has been done so far?
doublej472
DD-WRT Novice


Joined: 29 Jun 2011
Posts: 2

PostPosted: Thu Jun 30, 2011 2:45    Post subject: Re: E2500 router Reply with quote
Thanks

Fractal wrote:
The CFE has been dumped and are just awaiting eko's response... The CFE dumped info is in this thread.

Fractal

http://www.dd-wrt.com/phpBB2/viewtopic.php?t=140536

doublej472 wrote:
How much of the software has been done so far?
Display posts from previous:    Page 1 of 1
Post new topic   Reply to topic    DD-WRT Forum Index -> Broadcom SoC based Hardware All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You can attach files in this forum
You can download files in this forum