I'm sure this is not recommended for a noob, but I was able to pick up this router at a thrift store for 3 bucks, and I would like to try dd-wrt on it. I have already read through the forum rules and the Peacock thread, in hopes of finding out how to perform the install without having to ask, but I could not find anything specific to this device, which I'm assuming is because support on it is a WIP. Should I use the WNDR3300 Instructions but substitute the extracted file above? Thanks.
I'm sure this is not recommended for a noob, but I was able to pick up this router at a thrift store for 3 bucks, and I would like to try dd-wrt on it. I have already read through the forum rules and the Peacock thread, in hopes of finding out how to perform the install without having to ask, but I could not find anything specific to this device, which I'm assuming is because support on it is a WIP. Should I use the WNDR3300 Instructions but substitute the extracted file above? Thanks.
When they say WIP they mean WIP. That build was just posted this morning (eastern) and is just a test build. By all means, though if you want to test it out and report any bugs or problems then feel free to do so!
When they say WIP they mean WIP. That build was just posted this morning (eastern) and is just a test build. By all means, though if you want to test it out and report any bugs or problems then feel free to do so!
I understand that, and am still wanting to try. I would just like to know the best way to proceed.
stride wrote:
works good as far as i can tell.. but How do I revert back the Netgear firmware? I have tried and does not seem to be working.
Flashed successfully, I just want to point out what I'm finding issues with:
-Wireless speed on 2.4 GHz is consistently around >1mbps - 5mbps (That's transfer from wireless computer to wired computer, was full speed on Netgear firmware)
-Whenever I try to enable the 5 GHz radio the router crashes (have to turn off then back on)
-Due to the slow speed, the webgui is painfully slow
Other than that it seems to be working well!
Edit: The speed issue seems to have been fixed when I reset the router to defaults. Still can't enable the 5 GHz radio though.
Edit 2: The problem appears to be with apply.cgi as whenever I try to do anything that requires it (enable security, for instance) the router either crashes or just gives me a white page.