Posted: Tue Jan 10, 2012 16:25 Post subject: Help WRT54GL After TFTP upload
Hi all ,
I got a problem and my router . i did custom firmware ,unfortunately power interrupted .
I referred
//Linksys wrt54 GL users please note that if flashing with tftp using dd-wrt firmware gives no results, original Linksys firmware from www.linksys.com is worth trying. If that works, do a hard reset and you can continue to flash with dd-wrt. In order to use the Standard firmware version, a MINI version MUST be used first.
Notes:
The -i specifies binary transfer mode. The transfer will fail if you don't specify this.
Start the command and then power up the router. There is no indication of any transfer until it is complete.
The uploading via this command is pretty slow ~5.7kB/s if you are using 10Mbps half duplex mode so it will take about 10 minutes to upload ~3MB image. When you're using 100Mbps full duplex mode, it will go much faster. After the transfer is complete, wait 2-3 minutes for the image to be written to flash//
I am getting reply through commend prompt . I did reset button 10 sec with power/ 10 sec power removed /with power .I am getting reply contentiously .Now i cant able to get GUI .Power and DMZ light blink continuously.LAN indication stable . there is no lights glow on that .
Please see the peacock announcement, note 6. _________________ SIG:
I'm trying to teach you to fish, not give you a fish. If you just want a fish, wait for a fisherman who hands them out. I'm more of a fishing instructor.
LOM: "If you show that you have not bothered to read the forum announcements or to follow the advices in them then the level of help available for you will drop substantially, also known as Murrkf's law.."