Posted: Wed Jan 18, 2012 10:42 Post subject: Superchannel Problem on Bullet M2
Hi
Am facing some difficulty with the superchannel setup on a Ubiquiti Bullet M2. Got the ddwrt firmware registered and subsequently got the superchannel registration done too. In Wireless setup, have enabled superchannel, but am able to see only the normal channels 1-11. The only option available for extension channel is upper for lower channels and lower for higher channels. The Bullet M2 is in Ap mode and have applied the BrainSlayer-V24-preSP2-18024 firmware. Did a similar procedure with a Ubiquiti Nanostation2 Loco and faced no problems with the superchannel.