As far as others say something about this, it would be rather simple: in firmware upgrade select "recover to default settings" and then flash the stock firmware. But I'm not sure that this applies to your router.
Don't do anything unless you are sure of what you do, otherwise you could brick your router. _________________ Asus RT-N16 running Kong 22200M kingkong-nv32k-broadcom with OTRW2
E4200 V1 running Kong 22200M kingkong-nv60k-broadcom with OTRW2
2 times Linksys WRT610N V2 converted to E3000 running Kong 19545M usb-ftp-samba3-dlna-nv60k-broadcom with OTRW2 (bridged with LAN cable)
Check the wiki for specific instructions and guidelines on your router. In most cases, you should be able to do a factory reset, then flash the factory firmware, then do another factory reset...but don't quote me on that. Again, look through the wiki; if you don't, and you screw up your router, that's on you. _________________ Click here for Eko beta Click here for Brainslayer beta >>>PEACOCK THREAD!<<<
Personal assistance is available but only if you give me money. And beer. Lots and lots of beer.