Posted: Sun Feb 26, 2012 3:49 Post subject: Issue flashing WRT150N from special flash
Hello,
short story shorter.... Accidentally flashed a K26 to it, jtag'ed and erased the whole deal. Got a CFE and hex'ed my MAC in. Was then able to TFTP an original linksys firmware, and then web flashed the special mini build #12548M
Firmware: DD-WRT v24-sp2 (07/22/09) mini
Now, after power cycling and doing a 30/30/30, I can't flash the STD version. If I do it via the web interface I get a time out error in chrome (or something along those lines) after the first 3 or 4 seconds of the flashing count down.
I tried to tftp the standard version, and it says it completed successfully yet the router just sits there with only the lan led light and the ping time never changes or goes away. Power cycled and it comes back up with the special mini version (which I'm unable to adjust anything as when you hit apply it just loads a blank page, and when you return to the settings page they are all as they were before I tried changing them)
Any help/ideas you can provide would be great!
Oh, and even though I hex'ed my mac into the CFE... I get this:
LAN MAC
00:1C:10:00:00:01
WAN MAC
00:1C:10:00:00:02
Wireless MAC
00:1C:10:00:00:03
Sounds like the typical browser error mentioned in the peacock announcement. If it isn't see number 4 and 11 in the peacock. _________________ SIG:
I'm trying to teach you to fish, not give you a fish. If you just want a fish, wait for a fisherman who hands them out. I'm more of a fishing instructor.
LOM: "If you show that you have not bothered to read the forum announcements or to follow the advices in them then the level of help available for you will drop substantially, also known as Murrkf's law.."
I'll try clearing the cache.. it's just odd even after the tftp of the generic standard build and waited a few minutes before power cycling I'm still getting the special version. Maybe I'll try tftp'ing it again and clear the browser cache....
