Posted: Thu Apr 19, 2012 20:17 Post subject: No channels over 11 seen on 18777 Bullet M2
Hi. This issue was fixed in the past, the Bullet M2 is unable to detect any channel over 11. At least they are not displayed, neither acquired when in Client mode. I should give a try on the Bullet 2 , but climbing again on the mast is highly unpleasant !!
Did perform a factory defaults reset, and tried again. No way.
If someone could give a try to this issue, and confirm it, so I can report to BS or Markus. By the way, Client mode on B-Only or BG-Mixed mode, and acting as repeater with a VAP (as usual).
Thanks, Michel _________________ 2x EOC-2160 - AP 2x14dB Yagy to 450m link
2x EOC-2160 - RP 2x17dB Panels - 2x 7Mbps
1x WRT54G v2.2 - V24-SP2 13577VPN Eko
All Senao EOC-2610 V1.10 Std 15362 BS
1x UBNT Bullet 2 - RP 18dB Panel - 11Mbps - 13Km link
Ok Sash. If I am telling it is not working, it is because is the case. I do work on a WiFi network with 16000 clients, and I mean what I do and how I do it.
I ask politely to other people to verify on their side if it works or not, as it could be something I missed, your answer, is usual of no help, but this time I will report to Markus about your attitude, and let him know that I will remove DD-WRT from the list of the possible firmware to be used on the network.
Tired of your comments !
Michel _________________ 2x EOC-2160 - AP 2x14dB Yagy to 450m link
2x EOC-2160 - RP 2x17dB Panels - 2x 7Mbps
1x WRT54G v2.2 - V24-SP2 13577VPN Eko
All Senao EOC-2610 V1.10 Std 15362 BS
1x UBNT Bullet 2 - RP 18dB Panel - 11Mbps - 13Km link