when you guys updated to 18777 on the 3700v2 did you guys reset to default?
The wiki says not to restore to defaults and just upgrade as is? I always restored and then did a 30/30/30 reset after wards. Is the 30/30/30 reset still needed or can i keep my current settings?
when you guys updated to 18777 on the 3700v2 did you guys reset to default?
The wiki says not to restore to defaults and just upgrade as is? I always restored and then did a 30/30/30 reset after wards. Is the 30/30/30 reset still needed or can i keep my current settings?
has anyone restored and caused a brick?
Restore to defaults, upgrade, wait for router to reboot (some routers take up to 5 min doing multiple restarts by itself - wait for it), restore to defaults (for the new firmware), reboot.
The wiki is full of errors by users who believe in some kind of magic and who believes that problem A is caused by B even if it is completely illogical.
30-30-30 is one of those magics and it will on a lot of routers get them into boot loader recovery mode on an ip address that the user doesn't expect.
He will believe that the router is bricked when he can't connect to it. _________________ Kernel panic: Aiee, killing interrupt handler!
I tried putting dd-wrt on my 3700 around 12-15 months ago, but I found that both Wired and Wireless performance and responsiveness was slower compared to the stock Firmware. Is this still the case?
I'd like to put dd-wrt back on, but the performance is important and I don't want to go through the hassle of the Flashing then restore process to to get the stock FW back on if it's still not working out.
I'm currently on the new DNS beta as well, if that helps.
I tried putting dd-wrt on my 3700 around 12-15 months ago, but I found that both Wired and Wireless performance and responsiveness was slower compared to the stock Firmware. Is this still the case?
I'd like to put dd-wrt back on, but the performance is important and I don't want to go through the hassle of the Flashing then restore process to to get the stock FW back on if it's still not working out.
I'm currently on the new DNS beta as well, if that helps.
Many thanks,
Jimster
I installed this on my wndr3700v1 yesterday. I've found both the wireless range and speed to be less than with the stock firmware. I hardly have wireless signal in my bedroom now where I used to have no problems. I'll likely be reverting to stock and wait until DD-WRT matures some more for this router.
I tried putting dd-wrt on my 3700 around 12-15 months ago, but I found that both Wired and Wireless performance and responsiveness was slower compared to the stock Firmware. Is this still the case?
I'd like to put dd-wrt back on, but the performance is important and I don't want to go through the hassle of the Flashing then restore process to to get the stock FW back on if it's still not working out.
I'm currently on the new DNS beta as well, if that helps.
Many thanks,
Jimster
I installed this on my wndr3700v1 yesterday. I've found both the wireless range and speed to be less than with the stock firmware. I hardly have wireless signal in my bedroom now where I used to have no problems. I'll likely be reverting to stock and wait until DD-WRT matures some more for this router.
You probably failed to look at the WNDR3700 & Atheros wireless settings on the wiki to properly configure them.. right.? _________________ LATEST FIRMWARE(S)
BrainSlayer wrote:
we just do it since we do not like any restrictions enforced by stupid cocaine snorting managers