Posted: Sun May 20, 2012 2:39 Post subject: I cannot log into user interface after flashing with dd-wrt
I have a dir 615 E4 and after flashing it with dd-wrt firmware, the page show me that the modem is being programmed and I was asked to wait. Suddenly there s a blackout. Since then I can never log into it again. No wifi is broadcast and it's just like dead
After that I read a few forum and I did what is mentioned in those forum such as hard reset 30,30,30. I also tried to enter the crash recovery page, emergency room but it seem nothing was done. I set fix computer ip 192.168.0.2 and gateway 192.168.0.1 then I ping it and this time I got reply from it but still i cannot enter the user interface.
Can any modem doctor help me to revive it back and please explain it clearly as I'm new to this modem firmware stuff. thank you