D-Dink DIR825 revb successfully upgraded.
- 2.4ghz Band ok like old build
- 5 gHz Band works now perfect!
- OpenVPN Daemon is running and i can connect
- USB Printer is working
Testing on WZR-HP-G300NH, it didn't reboot during the upgrade process but according to the timeline it was fixed in Changeset 19328.
Wireless traffic graph is still not working, shows no activity. I have the device setup as an AP/bridged.
Otherwise working fine. _________________ WZR-HP-G300NH [B0 B0]
WHR-G300N V1 (Ralink)
Flashed web update, w/ reset to defaults, fine however (and I cannot remember prior version) Port Triggering is whacky once you get 2 entries in the list.
I can add 2 entries to the Port Triggering screen and save/apply fine however add a 3rd line or more and a save/apply crashes with a `No Repsonse` error on the apply.cgi
Come to find httpd service is crashed out of process list and while I can re-launch it it continues.
Appears at this time no way to add more than 2 entries in Port Triggering without it crashing the http daemon and have to issue a reboot to reset.
Will have to check tickets and see if it's been logged. Anyone else confirm?
[Edit] Happens in Chrome, Firefox and IE with cached or cleared cache.
[Edit] Happens after full flash (no web upgrade) and 30/30/30 reset.
After flashing the firmware, the device tries to restart. Power LED stays red, LAN LED gets green if you attach something.
However, not reachable. Doesn't seem to launch the firmware.
I tried flashing both the factory.bin and the other .bin with the webinterface and the emergency firmware uploader. Results are the same. (Exception: The non-factory .bin gets rejected by the original webinterface).
WNDR3700 V1 - only thing I've noticed so far on this build is that the wireless bandwidth graphs for ath0 and ath1 still appear to not show the proper bandwidth statistics when the traffic comes and goes through the WAN port.