Posted: Sat Jun 09, 2012 9:41 Post subject: Who uses O.T.R.W on a K24 router?
Guys,
Im looking for someone who installed OTRW on a K24 router.
And is willing to test my optware setup!
I created a new otrw repository which is based on fraters original scripts.
Since he is absent the last... and his scripts need some work to funtion in the recent builds.
Installation is the same as the original OTRW but with updated and additional scripts which include fixes.
All is working fine for K26. which is tested by a couple of users.
I'm close to releasing it to the public and this is the last part which needs to be tested before i'm confident
But since i don't own a K24 router I need someone to test...
Joined: 26 Jan 2008 Posts: 13049 Location: Behind The Reset Button
Posted: Tue Jun 12, 2012 18:41 Post subject:
I do but I am not in a position to test anything atm.
I have all of optware installed (otrw) but am only running xinetd and pixelserv currently. I turned off all the blocks (asiablock, stophammer, worldblock, etc), and never ran much else. _________________ [Moderator Deleted]
Even for pixelserv there is a small fix
when adding additional blacks and names are similar.
like adding 'rad.msn.com' when 'a.rad.msn.com' is already in the list
Joined: 06 Feb 2010 Posts: 7401 Location: Little Rock
Posted: Wed Jun 13, 2012 1:11 Post subject:
Just for the record - The E4200 doesn't run K2.4 NEWD builds.
basmaf, i can test it perhaps this weekend, i don't have enough time during the week to test it due to work, but i do have an Asus WL-520gU and WL500gP v2 that runs NEWD builds, just have to dig em out of the closet. _________________ Wireless N Config | Linking Routers | DD-WRT Wiki | DD-WRT Builds | Peacock - Broadcom FAQ
Just for the record - The E4200 doesn't run K2.4 NEWD builds.
basmaf, i can test it perhaps this weekend, i don't have enough time during the week to test it due to work, but i do have an Asus WL-520gU and WL500gP v2 that runs NEWD builds, just have to dig em out of the closet.
Just run the scripts. only a reboot after installation is needed to start all correctly.
mounting to /tmp/www will be done for you.
mypage will take care of creating nvram values.
no setup needs to be done all is enabled by default.
bwmon scripts will be started with default values.
bwmon will generate a userlist for you when host names are available in the arp table otherwise auto-added will be used.
userlist is shown on the bwmon page. also it's location.