Posted: Sat Jun 16, 2012 1:54 Post subject: Nanostation M2 Cannot install DD-WRT
I have tried to install DD-WRT on to my Nanostation M2 and the tftp acts like the upload worked,
I set the device in configuration mode,
I use tftp -i 192.168.1.20 put NS2M-DD-WRT.bin
(here is where the upload reports successful)
Then my lights continue to blink as if still in config mode (this does not happen when flashing back to AirOS.)
While watching my command line the pings will come in at 3000+ ms and then back to <1 and then time out and will rotate like that for hours. I try to power cycle at this point and once the device reboots I am unable to ping it at 192.168.1.20 or 192.168.1.1.
I have gone through the forums and downloaded all the versions that I can find in hopes that this is the issue, however still now luck. I have my professional license ready to go, if you could please fill me in on the step that I am leaving out.
Sash please don't say "read:" =( I have been reading for the last 8 hours and my brain hurts.
AirOS works just fine, once I load ddwrt the lights continue to flash until I wait the 7 minutes and power cycle. Once I power cycle the device boots up and no longer cannot be pinged at 192.168.1.1 or 192.168.1.20.
There must be something I am missing since it looks like so many have gotten it to work, any ideas?
I have a Nanostaion M2, I ended up flashing back to the original firmware and just using an openmesh router to provide the splash page the customer needed. I can't imagine that I was doing anything wrong, myself and another tech both worked on this and had the same results.
Thought this might help others as I have been pulling out my hair trying to get DD-WRT on my Nanostation M2. After repeatly trying the suggested firmware in the router database NS2M-DD-WRT.bin could not get it to load ever.
I then tried firmware in the under other downloads › others › eko › BrainSlayer-V24-preSP2 › 2012 › 03-08-12-r18767 › ubnt_NanoStation_m2 This did load, I could connect in client mode to my home AP but couldn't get other clients to connect to my virtual Interface on my M2.
So finally I thought I would give the Nano Loco M2 beta firmware a try. So far 24 hour in it's working great. Connecting 2 laptops, 2 Android Phones and 1 Android Tablet to Virutal Interface. Me Happy NOW.
nobody asked him what airos is installed! _________________ Forum Guidelines...How to get help
Throw some buzzwords into the WIKI search
I'm NOT rude, just offer pure facts!
Atheros (TP-Link & Clones, etc ) debrick service in EU
Guide on HowTo be Safe, Secure and Protect Your Online Anonymity!
Andreas Baumert: "Kundige Menschen befragen Fachleute, ohne ihnen auf die Nerven zu gehen. Sie stellen keine Fragen, die sie mit etwas Fleiß und Lektüre selber beantworten können. Sie wissen, auf welche Quellen es ankommt,und wie man sich Zugang zu ihnen verschafft."
My Nano M2 is V5.3.5
Tried all the newest airos upgrades on my Verison V5.3.5 M2 and also tried the V5.5 and V5.5.2 updates.
All 3 airos firmware updates worked on my M2
None would allow dd-wrt Nanostation M2 beta builds to load.
Only "Loco M2" beta loads and works on my "M2".