Upgraded this to my WBMR-HP-G300H and everything else seems to work quite nice but devices connected ton LAN ports can´t ping each other. WLAN to LAN pings fine...
Upgraded this to my WBMR-HP-G300H and everything else seems to work quite nice but devices connected ton LAN ports can´t ping each other. WLAN to LAN pings fine...
Upgraded this to my WBMR-HP-G300H and everything else seems to work quite nice but devices connected ton LAN ports can´t ping each other. WLAN to LAN pings fine...
I have the same problem.
thanks for heads-up, same issue here. back to old build.......
EDIT: I first thought everything was ok with my TPLink WR941ND, but it's not quite the case. The wireless speed was AGAIN painfully slow. And it's it has been like that since built 18007. I tried all kinds of different setting and combination and went back to stock, after all, since the WiFi is virtually unusable.
are you using a switch? if so it would. I have a switch and no problem pinging devices connected to switch. LAN port to LAN on router, no pings. I re-flashed it again just to test and result is the same.
apparently this not a new issue, see post below...
EDIT: not sure what this means… from laptop (Wi-Fi) I could ping any device connected to LAN (switch) however from Desktop(switch) I can’t ping laptop. Going to give r19342 another chance, tomorrow I will see if tunneling still works. If the tunnel still works I may just let continue to use it
just upgraded the last FW... but now the error at my wrt160nl is the wireless mac is the same as wan mac.... with the last fw (03-08-12-r18767) it used to give me a complete different mac address, not with the new one (06-08-12-r19342) it repeats the same mac to wan and wireless =/ any news, or solution???? cheers
Tried 06-08-12-r19342 for Dlink DIR-601a1.
I found that the extension channel options are fixed (ie. ch 11 only shows 'lower' in the dropdown now).
But one of my wired ports did not seem to be bridged to the other clients anymore. Possible bug? I'm not sure. I reverted back to 03-19-12-r18777 and everything was working again as expected.