|
Author |
Message |
wickedpenguin DD-WRT Novice
Joined: 28 Jun 2012 Posts: 6
|
Posted: Sat Jun 30, 2012 20:16 Post subject: Can't setup router to Adsl router setup - E2500 + x3000 |
|
Hi All,
I have just flashed my E2500 with DD-WRT an din the process of setting it up.
1. I have connected the lan 1 from the my x300 adsl router to the internet port in my e2500.
2. Changed the setup on my e2500 to asutomatic DHCP, but I don't have internet access.
I have tried other variations, like bridged mode on my x3000 and then pppoe on my e2500, but still no luck,
If I connect directly to my x3000 it works fine and is setup using a pppoa connection to my isp.
Also, if I check my e2500 router under status and WAN, it has an ip address and the correct DNS etc..
Any help would be greatly appreciated.
Thanks,
Last edited by wickedpenguin on Sat Jun 30, 2012 21:02; edited 1 time in total |
|
Back to top |
|
|
Sponsor
|
|
|
glio DD-WRT Novice
Joined: 30 Jun 2012 Posts: 10
|
Posted: Sat Jun 30, 2012 20:43 Post subject: |
|
Try setting your DSL router to make the port connected to the E2500 a DMZ. |
|
Back to top |
|
|
wickedpenguin DD-WRT Novice
Joined: 28 Jun 2012 Posts: 6
|
Posted: Sat Jun 30, 2012 20:59 Post subject: |
|
glio wrote: | Try setting your DSL router to make the port connected to the E2500 a DMZ. |
The port or the ip? Also, I can't seem to find the DMZ section on the cisco router, default firmware. |
|
Back to top |
|
|
glio DD-WRT Novice
Joined: 30 Jun 2012 Posts: 10
|
Posted: Sun Jul 01, 2012 11:25 Post subject: |
|
Sorry, I meant the IP for your DD-WRT router. I'm not sure where to find the DMZ setting on your DSL router but it should be there. |
|
Back to top |
|
|
|