Posted: Fri Jul 06, 2012 3:24 Post subject: Setting up a repeater bridge
I am trying to extend my wifi network using repeater bridge mode using a WRT54GS v1 as the primary and a WRT54G2 v1 as the repeater. The WRT54GS is running "DD-WRT v24 (05/20/08 ) mega (SVN revision 9517M Eko)" and the WRT54G2 is using "DD-WRT v24-sp2(07/22/09) micro (SVN revision 12548M NEWD Eko)"
I still cannot connect from the repeater to the primary. I have disabled wireless security and MAC filtering on the primary. On the Status > Wireless > Site Survey page of the repeater I can see the ssid of the primary, but under the Open column it says "No". I have tried rebooting the primary but not a hard reset since I have some custom vlaning setup on it.
Hi yesterday, i manage to connect one netgear router and a linksys exactly as what you want.
I follow this tread http://www.dd-wrt.com/wiki/index.php/Repeater_Bridge.
The diference is that i am using the mac address to filter my pc's and another thing that i did not find in the tread is at the end go to status-wireless on the secondary router and click on site survey there you should se your primary router click on join just see that the primary router the ssid does not change.
hope this helps
Thanks for the reply jorgeg73. I managed to get it going once I took the repeater to its permanent location (with a non-DDWRT primary router). All the settings I had set were good, there must be some sort of compatibility issue between the f/w on my primary DDWRT router and the repeater.