Soldering RPSMA onto the PCB of a Eng2611

Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Senao Devices
Author Message
schouwenweb
DD-WRT Novice


Joined: 30 Aug 2009
Posts: 12

PostPosted: Sun May 13, 2012 13:46    Post subject: Soldering RPSMA onto the PCB of a Eng2611 Reply with quote
About the PCB ENG2611,

I want to solder directly a RPSMA onto the PCB.

So that I can bypass the External switch (since it doesnt work on Rev. 1.3.1)

-> http://www.dd-wrt.com/wiki/index.php/EOC-2610

On the PCB there is a TX and RX connector.

My question:
How to solder the wires ?
Sponsor
Sash
DD-WRT Guru


Joined: 20 Sep 2006
Posts: 17417
Location: Hesse/Germany

PostPosted: Sun May 13, 2012 20:05    Post subject: Reply with quote
the switch doesnt work?
is it a gpio driver switch?
then get us the correct gpio settings.

_________________
GEGEN die EEG-UMLAGE auf EIGENVERBRAUCH!
_________________
Forum Guidelines...How to get help
&
Forum Rules
&
RTFM/STFW
&
Throw some buzzwords into the WIKI search Exclamation
_________________
I'm NOT rude, just offer pure facts!
_________________
Atheros (TP-Link & Clones, etc ) debrick service in EU
_________________
Guide on HowTo be Safe, Secure and Protect Your Online Anonymity!
schouwenweb
DD-WRT Novice


Joined: 30 Aug 2009
Posts: 12

PostPosted: Sun May 20, 2012 13:12    Post subject: Reply with quote
Problems with Eng2611 hardware ver. 1.3.1

Seems like stated as in the top Wiki link that the switch is not working. Tested thoroughly.

In the link is mentioned that a external antenna can be soldered to the pcb.

Soldered as following, using the cable what was soldered to the pcb-switch internal.

signal to the TX internal
shield to a grounded point

Still no difference though. I can be that the AP had already a damaged radio.

My question about this solder solution: did i overlooked something ?

pcbman
DD-WRT Novice


Joined: 27 Jul 2012
Posts: 1

PostPosted: Fri Jul 27, 2012 17:39    Post subject: Reply with quote
I also want to solder a RPSMA onto my pcb. how can i solder the wires?
_________________
PCB quote
Farchiecotter
DD-WRT Novice


Joined: 24 Feb 2013
Posts: 2

PostPosted: Sun Feb 24, 2013 9:49    Post subject: Reply with quote
It's a little tricky for beginners. Better ask someone from your area to help you out.
_________________
valuepointdistribution
Display posts from previous:    Page 1 of 1
Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Senao Devices All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum