Posted: Thu Aug 16, 2012 0:07 Post subject: belkin f5d7230-4 v2000 - can only ping during reset?
After flashing dd-wrt firmware, i try to connect to the webgui but couldn't get to it. So i tried to ping the router 192.168.1.1 with my system ip 192.168.1.3 and i got destination unreachable. So then i tried to ping to the belkin router default gateway 192.168.2.1 with my system ip 192.168.2.3 and got no luck either. But then i did a ping -t on the router default gateway and reset it, it returned a reply with ttl=100 for a few seconds and after a while it became destination unreachable again. I tried hard reset a couple of times but that didn't solve the issue.
So is my router bricked or not? Is there any way to save it?
Joined: 24 Oct 2008 Posts: 1079 Location: Latin America
Posted: Fri Aug 17, 2012 15:47 Post subject:
Something went wrong with your procedure.
So, since you can ping it at boot time, tftp the firmware again.
But first, double check you are using the correct file. _________________ If you want support, please read first the announcements and forum rules.
Si usted desea ayuda, por favor lea primero los anuncios y las reglas del foro.
Last edited by feliciano on Fri Aug 17, 2012 23:10; edited 1 time in total
TTL 100 is your bootloader, so you might be in luck. Try and initiate a tftp transfer during the ping responses. Timing is critical. _________________ James
Main router:
Netgear R7000 overclocked to 1.2GHz - DD-WRT v3.0-r35965M kongac
IPv6 6in4 (HE.net), OpenVPN (with PBR and split tunnelling), Entware, dnsmasq with ipset
I tried tftp a few times, still having the same issue.
I am using Bv2000 Micro SF, which i got directly from the database.
Is there anything else i could try?
Thanks again!
Joined: 24 Oct 2008 Posts: 1079 Location: Latin America
Posted: Wed Aug 22, 2012 23:12 Post subject:
As James2K said: timing is critical.
So;
Connect directly to a LAN port of the router
Set your PC to an static IP address, say 192.168.1.11, and force it to 10Mbps half duplex
Open two command prompt windows, in one do a ping 192.168.1.1 -t, and in the other write tftp -i 192.168.1.1 PUT firmware.bin but don´t hit enter yet
As soon as you see ping responses, hit enter in the other window
Wait until finish upload
If it doesn´t work, try a different build.
If it doesn´t solve your problem, you´ll have to research about JTAG and/or serial recovery. _________________ If you want support, please read first the announcements and forum rules.
Si usted desea ayuda, por favor lea primero los anuncios y las reglas del foro.