Posted: Sun Jul 27, 2014 21:53 Post subject: brick tp-link tl-wr841nd v8
Hello, first of all, sorry for my language, I'm using google translator.
download from the firmware page for tp-link tl-WR841ND v8, which recommends a generic image, but the fact remained install a brick.
Because I go to pc and lei me all the tutorials and I can not revive.
through serial console cable and I can access it but I manage not to install another firmware.
attached the boot log.
I need your help
Thank you
thank you very much TendaW311R
I was following these tutorials a long time but never reaches my router "Autobooting in 1 seconds"
caracacteres besides the above, when you start, seem strange
I attach the log back boot
OK, but when power the router you must see U-Boot () .... and then autobootin message and after all starting kernel. The first lines of bootlog are unreadable for me. Others start the kernel. You need this which are unreadble. Try to solder again to avoid bad solder joint. Try another usb-ttl adapter if possible.
the cable was already used in the same router to repair an error like with an image of openwrt and it worked
but this image of ddwrt starts well, with those unreadable parameters, probe to change speeds, but nothing worked for me
I will try to review the contacts
thank you