[sync]

i currently have a WRT350N with build r24461 ftp://ftp.dd-wrt.com/betas/2014/06-23-2014-r24461/broadcom/dd-wrt.v24_vpn_generic.bin

i am needing to set up pppoe with wan with vlan10

by default wan is vlan2

in Setup -> VLANs - for the WAN i checked VLAN10 and also checked Tagged

apply the settings, still can't connect

i then went to Setup -> Networking and changed the "WAN Port Assignment" from vlan2 to vlan10

i'm still unable to connect, rebooted the router and check the settings in

Setup -> VLANs = all looks good
Setup -> Networking = "WAN Port Assignment" went back to vlan2

i then rolled back to 10011 and everything works fine,

so is there a problem when trying to change the wan vlan from vlan2 to vlan10 in the Setup -> Networking - "WAN Port Assignment" ?

[meckanix]

I'm also seeing the same issue on verison DD-WRT v24-sp2 (05/19/15) giga - build 26947M, using an ASUS RT-AC66U.

Either setting the WAN vlan via:

Setup -> Networking and changed the "WAN Port Assignment" from vlan2 to vlan11

or

nvram set wan_default=vlan11
nvram set wan_iface=vlan11
nvram set wan_ifname=vlan11
nvram set wan_ifnames=vlan11
nvram set wan_ifname2=vlan11


but everytime it reboots after an nvram commit or the unit is power cycles the wan vlan defaults back to vlan2

Any insight would be greatly appreciated