Posted: Tue Nov 18, 2014 16:55 Post subject: [BRICKED] TP-Link TL-WR841N V8
Excuse me for my poor English.
I live in Argentina.
Well... I've a TP-Link TL-WR841N. I put the firmware DD-WRT but flash it will send another version (ie the one I've is the TP-Link TL-WR841N V8 and I will send V7.x.
The Power light is on. The other lights were flashing... it impossible to access the router on the LAN/WAN ports.
Here how I relive?
There is a procedure to revive without connecting with some additional wiring?
I am looking for the steps but cann't find it anywhere.
I already have the USB adapter that emulates RS232 Serial Cable.
RS-232 is +12V/-12V signal level, your routers serial port is 3V/0V TTL level.
You need to use a USB<->TTL serial adapter, not a USB<->RS-232 _________________ Kernel panic: Aiee, killing interrupt handler!
Chipset Silabs CP2102
Terminal de lineas de pines de 0.1"
Full-speed USB 2.0 12Mbps
Soporta X-On/X-Off
14 señales disponibles DCD,RXD,TXD,DTR,GND,DSR,RTS,CST,RI,VBUS,SPD,SPD\,3V3,5V
Terminal instalado en RTS,3V3,5V,TXD,RXD,GND.
Baud rate 300 bps a 1.5 Mbps
Buffer de recepción y transmición
Soporta Windows 98SE,2000,XP,Vista,Windows 7, MAC OS 9, MAC OS X y LINUX 2.40
Tamaño: 54 x 17
Peso: 7g
If low speed port me these strange symbols appear.
When I upload more, appear stranger still
ENET1 port0 up
dup 1 speed 1000
Using eth1 device
TFTP from server 192.168.1.100; our IP address is 192.168.1.111
Filename 'openwrt-ar71xx-generic-tl-WR841N-v8-squashfs-factory.bin'.
Load address: 0x80000000
Loading: * T T T T T T T T T T
Retry count exceeded; starting again
link down eth0
After finished all the steps, the LOG throws the following:
Autobooting in 1 seconds
## Booting image at 9f020000 ...
Uncompressing Kernel Image ... Too big uncompressed streamLZMA ERROR 1 - must RESET board to recover