Tomax
DD-WRT Novice
Joined: 09 Feb 2015
Posts: 5
|
 Posted: Mon Feb 09, 2015 20:37 Post subject: Feixun FWR-734N |
 |
Hi,
I'm new to the router modding world.
I've seen a few times this forum when i want to change some router firmware to DD-WRT and so far is the best I've tried.
I have a Feixun FWR-734N (Currently working) and i thought if it's possible to flash with dd-wrt. I've search and found little to nothing about this router (maybe because it's a Chinese one?  ).
I'm good with electronic and, after read for a while I got the serial communication working (Since I can't find the FCC-ID for detection) and can provide some material I personally couldn't analyze, or at least turn into something useful.
So far I got:
Flash size 4Mb (according to data-sheet)
Ram size 16Mb
Ralink SoC
My question is, can I, somehow flash DD-WRT on my device? If so can someone point me some direction in order for me to follow?
A similar model would be the dlink-dir615h (?)
I'll appreciate any help, thanks.
| Code: |
U-Boot 1.1.3 (Sep 16 2011 - 11:09:54)
Board: Ralink APSoC DRAM: 16 MB
relocate_code Pointer at: 80fb0000
spi_wait_nsec: 3c
spi device id: c2 20 16 c2 20 (2016c220)
find flash: MX25L3205D
raspi_read: from:30000 len:1000
.*** Warning - bad CRC, using default environment
============================================
Ralink UBoot Version: 3.5.2.0
--------------------------------------------
ASIC 3352_MP (Port5<->None)
DRAM_CONF_FROM: Boot-Strapping
DRAM_TYPE: SDRAM
DRAM_SIZE: 128 Mbits
DRAM_WIDTH: 16 bits
DRAM_TOTAL_WIDTH: 16 bits
TOTAL_MEMORY_SIZE: 16 MBytes
Flash component: SPI Flash
Date:Sep 16 2011 Time:11:09:54
============================================
icache: sets:256, ways:4, linesz:32 ,total:32768
dcache: sets:128, ways:4, linesz:32 ,total:16384
##### The CPU freq = 400 MHZ ####
estimate memory size =16 Mbytes
Please choose the operation:
1: Load system code to SDRAM via TFTP.
2: Load system code then write to Flash via TFTP.
3: Boot system code via Flash (default).
4: Entr boot command line interface.
7: Load Boot Loader code then write to Flash via Serial.
9: Load Boot Loader code then write to Flash via TFTP.
You choosed 4
0
raspi_read: from:40028 len:6
.
4: System Enter Boot Command Line Interface.
U-Boot 1.1.3 (Sep 16 2011 - 11:09:54)
RT3352 #
############ After boot (Option 3) Those are the 1st lines to appear
## Booting image at bc050000 ...
raspi_read: from:50000 len:40
. Image Name: Linux Kernel Image
Created: 2011-09-16 3:08:15 UTC
Image Type: MIPS Linux Kernel Image (lzma compressed)
Data Size: 3324305 Bytes = 3.2 MB
Load Address: 80000000
Entry Point: 8022a000
raspi_read: from:50040 len:32b991
|
|
|
