johnkeates
DD-WRT Novice
Joined: 14 Apr 2009
Posts: 4
|
 Posted: Mon Apr 06, 2015 18:57 Post subject: Device support request (Devolo WiFi Repeater RaLink RT3352F) |
 |
Edit: turns out, this device is pretty much the same and has the same ID silkscreened on the PCB: https://wikidevi.com/wiki/Aztech_WL559E
I have a Devolo WiFi Repeater, it's a small plug-pack sized "repeater" with Ethernet.
It has a reset button and a WPS button, and a few GPIO's doing some LED flashing.
Internals:
Ralink RT3352F SoC
DDR2 RAM: Zentel A3R12E40CBF (64 MByte / 512 Mbit)
SPI Flash: MX25L3205D (4 Mbyte / 32 Mbit)
Boot log (cut off just before the kernel boots, and a few U-Boot menu items):
| Code: |
U-Boot 1.1.3 (Apr 4 2012 - 11:52:28)
Board: Ralink APSoC DRAM: 64 MB
relocate_code Pointer at: 83fb0000
******************************
Software System Reset Occurred
******************************
spi_wait_nsec: 3c
spi device id: c2 20 16 c2 20 (2016c220)
find flash: MX25L3205D
raspi_read: from:30000 len:1000
.*** Warning - bad CRC, using default environment
============================================
Ralink UBoot Version: 3.6.0.0
--------------------------------------------
ASIC 3352_MP (Port5<->None)
DRAM_CONF_FROM: Boot-Strapping
DRAM_TYPE: DDR2
DRAM_SIZE: 512 Mbits
DRAM_WIDTH: 16 bits
DRAM_TOTAL_WIDTH: 16 bits
TOTAL_MEMORY_SIZE: 64 MBytes
Flash component: SPI Flash
Date:Apr 4 2012 Time:11:52:28
============================================
icache: sets:256, ways:4, linesz:32 ,total:32768
dcache: sets:128, ways:4, linesz:32 ,total:16384
##### The CPU freq = 400 MHZ ####
estimate memory size =64 Mbytes
raspi_read: from:40028 len:6
.
NetTxPacket = 0x83FE4940
KSEG1ADDR(NetTxPacket) = 0xA3FE4940
NetLoop,call eth_halt !
NetLoop,call eth_init !
Trying Eth0 (10/100-M)
Waitting for RX_DMA_BUSY status Start... done
Header Payload scatter function is Disable !!
ETH_STATE_ACTIVE!!
Please choose the operation:
1: Load system code to SDRAM via TFTP.
2: Load system code then write to Flash via TFTP.
3: Boot system code via Flash (default).
4: Entr boot command line interface.
6: Entr Aconfig mode.
7: Load Boot Loader code then write to Flash
|
It doesn't have homeplug/powerline or anything like that (which is what Devolo usually has).
Few pictures attached of front and back of SoC board and one of the power supply to show how the 2nd button is connected (since it's not on the SoC board). Also has a nice serial port located on the side next to the LED board, works fine.
How hard would adding support for the board be? |
|
