[pentySVK]

Hello

Is there any way to set router into this settings:
wan+lan1+lan2= as unmanaged switch-without dhcp, nat etc... only as dump switch

and

wan/this same wan as above/+other LAN ports+both wifi(2,4ghz&5ghz) have normal routered

router is linksys ea6400 with newest BS build

sorry for my bad english

[Per Yngve Berg]

Not clear what you want, but i think you want to set the router as an AP with the wan port assigned to the switch.

http://www.dd-wrt.com/wiki/index.php/Wireless_access_point#LAN_Uplink_Through_WAN_Port

The wan port is by default set to vlan2. You have to move it to vlan0 or vlan1

Use "nvram show | grep vlan.*ports" from ssh/telnet to see what the vlan ports are.

[Per Yngve Berg]

More information on how to set up vlan on the switch.

http://www.coertvonk.com/technology/networking/dd-wrt-leading-two-seperate-networks-5829

[pentySVK]

I make this on picture


I want turn of DHCP,but only for port 1&2

I need it for my IPTV set-top-box


//it also work if I set this settings http://event.asus.com/2012/nw/dummy_ui/en/Advanced_IPTV_Content.html on ASUS routers

Is there any way to set this same in DDWRT?

[Per Yngve Berg]

You should have posted in the Broadcom Forum.

I believe you have a BCM4708A0 chipset. The same as the Asus RT-ac68u.

To split out two port into vlan3

nvram set vlan3hwname=eth
nvram set vlan3ports="3 4 7"
nvram set vlan1ports="1 2 7*"
nvram commit
reboot

See my Topic on how to configure multicast.
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=264294&highlight=choke+multicast

[pentySVK]

Ok, I go try it

It doesnt work, I order http://datacomp.sk/tp-link-tl-sg1005d-5xrj45-10-100-1000mbps-switch-_d89107.html#.Vdn0K_SbJj8 and I connect it before router

ISP- switch- settopbox -router- other devices

its more easy way

thanks for help