Your reports for Ralink/Mediatek units are highly appreciated !
Router:
Firmware:
Kernel:
Status:
Reset:
Errors: _________________ THERE ARE NO STRANGERS HERE; ONLY FRIENDS YOU HAVEN'T YET MET.
________________________________________________________________________________________________________
DD-WRT CHANGELOG | DEVICES | DD-WRT BUILDS | KONG BUILDS | UNOFFICIAL BUILDS | DD-WRT in VIRTUALBOX
Router: buffalo wcr-gn
Firmware: DD-WRT v3.0-r27745 std (08/25/15)
Kernel: Linux 3.2.71 #18665 Tue Aug 25 08:09:51 CEST 2015 mips
Status: stable
Reset: no
Errors:AOS button can not ture off radio and no reset button
DIR-615 rev.H
updated from r27734 to r27745,
w/o 30/30/30,
w/o reset,
restored settings from file,
seems to work properly in router and repaeter bridge mode,
SSH working,
reset button not working.
Router: Dlink DIR-810L A1
Firmware: DD-WRT v3.0-r27745 std (08/25/15)
Kernel: Linux 3.10.87 #1077 Tue Aug 25 08:31:55 CEST 2015 mips
Status: ok
Reset: no
Errors: Wrong Router model on status page, says DIR 810L B1.
5Ghz did not start after update. Did a, power off, power on, edit any 5ghz setting(SSID). Then and after reboot it starts working again.
Joined: 29 May 2008 Posts: 243 Location: United Kingdom
Posted: Fri Aug 28, 2015 23:40 Post subject: D-Link DIR-615 D2
D-Link DIR-615 D2 (Europe)
Upgraded from r27600 then reset to defaults, Everything seems to be good however PPTP client or WAN Setup dos NOT work. When i enabled this via "WAN Setup" the internet light goes Orange same by going into Services -> VPN -> PPTP Client this method do not work aswell.
Automatic Configuration DHCP via a another Router on 192.168.0.0/24 subnet gets a IP great but VPN both PPTP/L2TP not working., The VPN network subnet would be 10.0.0.0/8 range so i cant see this been an issue.
The username or password contain no spaces, Just letters and numbers. _________________ TP-Link TL-WDR3600 v1 [EU]: r36330 (07/16/18 )
D-Link DIR-615 D2 [EU]: r36330 (07/16/18 )
Mikrotik RB750r2 (OpenWrt 17.01.4)
EE BrightBox 1 aka A4001N (OpenWrt 17.01.4)
Sagemcom FAST@5364 (VDSL2,FTTC (Fibre to the Cabinet) Synced 65/17
Router: Buffalo WHR-300-HP2D
Firmware: 27745
Kernel:
Status: Stable
Reset: Yes
Errors: No WAN port
I flashed back to Buffalo stock to confirm the WAN port is physically OK. Flashed in 27745 with reset. Tried to pick up DHCP from spare DDWRT router with no luck. Static settings didn't work either.