[chester_40391]

I have Ubiquity Bullet M2 and am trying to figure out how to trunk the physical interface to pass traffic to a vlan aware Cisco switch. I have multiple VAP's each bridged to their own vlan.

I have dug through the internet looking at how to's, videos, wikis etc but cant seem to find the right pieces to put it together in my scenario. The Ubiquity Bullet only has 1 physical interface and I am using V3 dd-wrt (paid) My interface does not look like those I find in similar how to's. Mostly I see how to's on moving the vlans from one port to another via the gui however my interface does not look like this. I also find some folks using command line to do this but I think its possible through the gui by now?

Thanks.