[justinjja]

I had an EA6200 running Kong 26500M.
Hardware was detected as something like northstar.

Wifi and everything else I tried seemed fine.
Reboots worked fine.

I changed it to wifi client bridged mode and rebooted and it didn't come back up.

The IP I set was 192.168.1.103
The IP 192.168.1.103 is pingable for about 30 seconds.
Reply from 192.168.1.103: bytes=32 time=1ms TTL=100

Then it stops responding to pings for 20 seconds.
Then all the Lan LEDs flash and it reboots. (And repeat)

I can't get TFTP to work.
Unable to get responses from the server.

I read that 30/30/30 will brick this router?

What should I try now?

[justinjja]

Hooked up a serial cable and ran this:
nvram erase all

Seems to up and running now.

[caziques]

what were your settings for the serial console ? i connect via putty but just get garbage ..

[justinjja]

I believe the settings you want are: Baud: 115200
Data bits: 8
Stop Bits: 1
Parity: none
No Flow control