Managed to flash the dd-wrt firmware all seems to be working OK.
1 question, is it correct that the Wi-Fi Protected Setup (WPS) button can not be used, and the orange light stays on all the time.
Will this be fixed in a future update?
Thanks
Managed to flash the dd-wrt firmware all seems to be working OK.
1 question, is it correct that the Wi-Fi Protected Setup (WPS) button can not be used, and the orange light stays on all the time.
Will this be fixed in a future update?
Thanks
there is no plans to incorporate the WPS feature in dd-wrt. It is actually a huge security flaw.
The wps button can be programmed to do different things like turn the radio on an off.
the wps light means different things depending on how the router is configured. If it is the main router / gateway, the light means it has a wan connection.
Hi all,
my name is Harry.
I hv a router, linksys e1000 v2, that flashed dd-wrt. i hv tried so many time follow the wiki to make it work in bridge mode, but no luck
my primary router that connect to modem is dlink dir 600.
Anyone pls help me out....
Thanks alot.
Posted: Mon Sep 17, 2012 12:25 Post subject: E1000v2 working well in repeater bridge mode
Just a note to say thank you for all the work & advice here. I loaded the firmware update onto my E1000v2 last night, and had it set up as a repeater bridge to my E3000 in about twenty minutes. All working fine.
Posted: Sat Oct 13, 2012 9:04 Post subject: Build 16758 or 16785 better for E1000 v2?
Which is best for a Linksys E1000 v2 - build 16758 as recommended in the posting of 9/4/2011 (http://www.dd-wrt.com/phpBB2/viewtopic.php?t=105008), or 16785 from the database (build date 21/4/2011, so not available at the time when 16758 was recommended)?
I just flashed my router with dd-wrt. What do i do now?
I did try this where after flashing my router e1000, i connected the ehternet wire from my isp modem/router from port 1 into, the wlan connection of my personal router e1000.
Then i disabled the wireless connection from my isp modem, and enabled it on my personal routser. Is this the correct way of doing it, or is there a better way. Or a different setting... etc?
Posted: Sat Nov 24, 2012 0:36 Post subject: Re: Linksys e1000v2 now supported
Does anyone know where I can get the big or mega file for the E1000 v2?
Eko wrote:
Linksys e1000v2 is now supported. Please use attached firmware for flashing. You can simply update from original firmware GUI. After flashing be sure to restore to factory defaults.
I'm having trouble with ipkg in that it won't update (produces no output). I've enabled JFFS through the web gui. Any ideas?
Edit: There seems to be an issue writing to the jffs partition. touch and mkdir commands execute without error, but nothing is actually created. The web gui reports 2176/0 usage..
Edit edit: I reformatted the partition (clean jffs) again and now I can write to it. However, it is only 384 KB with 188 free. Shouldn't I have 4MB?