[virtualahmad]

I have the linksys WRT54GL running "A" version of dd-wrt... its been a while since i installed, maybe over 6-8 months. I also have a microsoft router. Internet connection is on the MS, and the linksys plugs into the MS unit to act as a repeater for wireless.

My problem.

1. I'm not knowledgeable about this
2. I can't access the control panel on the linksys... it was left at the default 192.168.1.1, but whenever i try to access it, i get page not found. this is with both wired and wireless connection. When wired to the linksys, i CAN access the MS unit control panel, which is at 192.168.2.1.

Any ideas or help will be much appreciated... i'm totally lost and need to add a MAC address to the wireless filter to allow access

[GunTolo]

try this ...

from the dos command in your PC (if you use windows) type "arp -a"
try one by one to type that IP show in your browser ... :D

and for the simple .... reset the linkys for 30 second and setup again ... so type the default IP (192.168.1.1) for the linksys in your browser ..

good luck

[virtualahmad]

thanks for the advice... had to resort to the reset...