[tav]

I have a WRT54GS version 1.0 sn:GGN1xxxx in the middle of the building.

Version V23 SP3 02/22/07

Configed as an AP, DHCP disabled, AP isolation disabled, WEP 128 bit.
Wan disabled. A monowall router plug into the WRT54 switch for internet.
Every else pretty much default. Plus a couple of Windows boxes.

A wet11 at each end of the building. One wet11 has linux boxes, the orher
mixed linux and windows.

All machines can see the internet. All machines can see the machines on the WRT54GS.
The problem is the machines on the two wet11s can't see each other after the intial setup from a ram reset. I need to enable and disable Ap isolation before they see each other. Sometimes it takes a couple of resets and reconfigs to get the wet11 machines talking to each other. Once I get things running it seems to stay this way until t view the router's web pages. Then the computers on the wet11s stop talking to each other.
At this point the only way I can get them to comunicate with each other is to do a ram
reset and reconfig the router.

I tried version v23sp2 first and just changed to sp3 with the same results.

Am I overlooking something when I configure the WRT54GS?

[tav]

Problem Solved.

The problem has to do with one of the WET11 bridges. When
it is replaced with another bridge AP isolation works as
expected.

The other WET11 seems to work ok and both WET11s work with
a linksys 802.11b router(WAP11). When I get a chance I plan
to check out the software revsions on the WET11s, just for the sake of art.