Yakuzza DD-WRT Novice
Joined: 31 Jul 2012 Posts: 3
|
Posted: Fri Oct 11, 2013 4:27 Post subject: TP-Link WR 703N, what to read on gpio use and udp recieving? |
|
Hi,
a while back i made a sketch for one of my arduino´s and now that i ordered this tiny router, i wonder how to do the same thing on it.
I don´t have the router since i just ordered it far east.
1. What to read upon to have a program listening to an UDP port 48880 and based on that
2. shifting the recieved command out to a 433mhz transmitter
, timing is critical since in betwwen there will be only 360µs delay since it´s for these home remote outlets, i intend to connect a 433mhz transmitter directly and not through a serial connection to another project that i saw.
I would like to have it compatible with the 2 remote Apps on www.power-switch.eu like my gateway sketch which is horrible but working code.
references:
http://board.homecontrol4.me/viewtopic.php?f=13&t=1549 <- horrible arduino code but working very well
www.power-switch.eu <- two Apps that are working
thanks
Yaku |
|