DIR-615 E3, flash went fine. Get appropriate wireless speeds. Wireless LED doesn't function (only has with Stock)
Speedtest.net gave me my correct results.
3meg up .5meg down AT&T DSL in Wisconsin.
Posted: Sun Mar 18, 2012 15:23 Post subject: No 5GHz Band DIR 825 RevB
5GHz band (ath1 interface) on DIR 825 Rev B is not working for me.
Status page says the radio is on, but it doesn't appear to pick a channel on "Auto" channel mode. If I manually try to set the channel, it still doesn't work. The "Channel" parameter just displays "Unknown" all the time. Build 18024 works fine.
oh yeah didn't notice that, bandwidth monitoring is broken on mine for wireless DIR615E3, it shows really tiny #s when I'm downloading high (downloading EQ1, its now free to play) LAN and WAN show correct though.
Connection gets reset 5 seconds into the flash. Router keeps working but site unavailable. Still on r18687 after reboot. Retried and redownloaded multiple times.
18024 - 18767 per webflash, works fine (reboot doesnt work autmatically but nvm)
- Samba Authentification response is very slow but samba itself works fine after this
- WLAN LED only works on datatraffic but dont show active/inactive WLAN
- De/activate wlan over QSS button (SES / AOSS / EZ-SETUP / WPS) dont work
-> setting to deactivate wlan on boot dont work, same as with 18024 (with 17xxx builds this worked)
-> yes reset button is active
Joined: 03 Jan 2010 Posts: 7568 Location: YWG, Canada
Posted: Sun Mar 18, 2012 18:36 Post subject:
Besides flashing fine and LAN LED colors fixed on WNDR3700, http://svn.dd-wrt.com:8000/ticket/2447 says it all. Reverting to r18740.. hope this isn't the start of QoS war again.
Don't even breathe on this build if you expect QoS. _________________ LATEST FIRMWARE(S)
BrainSlayer wrote:
we just do it since we do not like any restrictions enforced by stupid cocaine snorting managers
Webflash on Buffalo WBMR-HP-G300H works ok.
Internet connection via internal modem works. Lan also ok. Airprint works.
Tx power can't be set. Changes are neglected. Airprint via vpn doesn't work.
No other problems so far. Development of firmware is on a good way. A good idea is in my opinion to change under WAN Connection Type, Advanced settings, Payload type the default setting to Bridged.
It didn't reboot to complete the flash again, same as 18687.
Had to power cycle it.
Wireless Bandwidth graphs still broken, otherwise working fine.
Not sure about QoS, I don't use it anymore. _________________ WZR-HP-G300NH [B0 B0]
WHR-G300N V1 (Ralink)