Posted: Thu Jul 10, 2014 21:30 Post subject: TL-WA801ND V1 Revert to stock firmware Error
Hi
this is my first post, i'm marco from rome...
this evening i've just loaded a dd-wrt firmware to my tl-wa801nd, but with no luck, because i can't repeate my near wep wifi, i try to inser all parameter, wep key ecc.. but no repeat...
so i decied to turn back usig revert package but when i try this i recive upgrade file...
can you help me ?
thank you very much.
ps. my dd-wrt version now loaded on the accesspoint is 24461.
Last edited by redstrat984 on Fri Jul 11, 2014 6:50; edited 1 time in total
Joined: 04 Nov 2012 Posts: 525 Location: Acapulco, Mexico
Posted: Thu Jul 10, 2014 22:06 Post subject:
Did you try this
Open the Wireless -> Basic Settings tab
Physical Interface Section
Wireless Mode : Client Bridge (routed)
Save
Default Gateway Mode : Manual
Gateway : Point to Gateway for network, usually IP of primary router
Wireless Network Mode : Must Match Primary Router
Wireless Network Name(SSID) : Must Match Primary Router exactly including exact case- Make sure you spell this correctly
Wireless Channel : Must Match Primary Router (This will disappear once you put it in RB mode, and isn't needed)
Network Configuration : Bridged
Save
Virtual Interfaces Section
Add
Wireless Network Name(SSID) : Same as the primary router (v24SP2 I have not had any problems with signal dropping)
[NOTE] - You CAN try using the same SSID but it usually will not work properly. Many have had random disconnects and/or no connection if the SSID's are the same.
Wireless SSID Broadcast : Enable
Save &
Apply Settings
Now set security. in same tab Wireless now click wireless security
By default is disable, set Clients and AP _________________ TP-Link: TL-WR741ND V4
TP-Link: TL-WR842ND V2
Did you try this
Open the Wireless -> Basic Settings tab
Physical Interface Section
Wireless Mode : Client Bridge (routed)
Save
Default Gateway Mode : Manual
Gateway : Point to Gateway for network, usually IP of primary router
Wireless Network Mode : Must Match Primary Router
Wireless Network Name(SSID) : Must Match Primary Router exactly including exact case- Make sure you spell this correctly
Wireless Channel : Must Match Primary Router (This will disappear once you put it in RB mode, and isn't needed)
Network Configuration : Bridged
Save
Virtual Interfaces Section
Add
Wireless Network Name(SSID) : Same as the primary router (v24SP2 I have not had any problems with signal dropping)
[NOTE] - You CAN try using the same SSID but it usually will not work properly. Many have had random disconnects and/or no connection if the SSID's are the same.
Wireless SSID Broadcast : Enable
Save &
Apply Settings
Now set security. in same tab Wireless now click wireless security
By default is disable, set Clients and AP
i've tryed anything...
my only hope is to resolve the upgrade failed when revert...
Today, router accept the revert package using internet explorer to flash, the unit say me Upgrade succesfull but when the unit reload, i've the same ddrwt firmware...no tp link firmare... 24461.... no change... only change is the hard reset..
if i try to load the previous version (24160) i've the same thing....
In another try, dd-wrt console, have loaded revert package but now the router load up with no dhcp, the wifi is up whit tplink 77c136 sid, but anything can't connect to wifi, and no ip to wired port.
i've tryed to assign a static ip link 192.168.1.2 or 192.168.0.2 to my pc whit no success...
