Posted: Mon Oct 24, 2011 12:16 Post subject: DIR-600 2.11 firwmare
Hello, i have tried to flash dd-wrt on 2.11 firmware on DIR-600 DLink but says incorrect image, i mean i boot my router into "emergency room interface"
I'm getting the "ïnvalid image file" message too so i read the emergency room method but I cannot figure out how to set my pc static ip on windows 7. I'd love a full explanation from someone. This is driving me mad!!!
Posted: Tue Apr 17, 2012 17:26 Post subject: assigning static ip
Thanks Joecop for your reply. I did get that far before but when entering the ip 192.168.0.0 as mentioned in the emergency room write up the config isn't accepted. I'm not sure what should go in the subnet and default gateway fields to correspond with the above ip. Your further assistance would be gratefully appreciated. Regards.