Posted: Sun Aug 19, 2012 14:11 Post subject: does ralink soc have CFE for nvram erase? dir600b wrgn23
I have a serial console hooked to a dir600b.
now is there CFE for this chip? If not how would I do nvram erase?
Is it available under the web interface or ssh?
Board: RT2880 DRAM: 32 MB
twe0 set to <NULL>
toe0 set to <NULL>
============================================
Ralink UBoot Version: 3.1 Alpha
--------------------------------------------
ASIC 3052_MP2 (MAC to GigaMAC Mode)
DRAM COMPONENT: 256Mbits
DRAM BUS: 16BIT
Total memory: 32Mbytes
Date:Jan 13 2009 Time:17:40:14
============================================
icache: sets:128, ways:4, linesz:32 ,total:16384
dcache: sets:128, ways:4, linesz:32 ,total:16384
Please choose the operation:
1: Load system code to SDRAM via TFTP.
2: Load system code then write to Flash via TFTP.
3: Boot system code via Flash (default).
4: Entr boot command line interface.
9: Load Boot Loader code then write to Flash via TFTP.
You choosed (52)
0 seconds ...
Eth0 (10/100-M) : ethaddr = (00:26:5a:ff:ff:ff) 00 26 5A ff ff ff
4: System Enter Boot Command Line Interface.
RT3052 #
RT3052 # help
? - alias for 'help'
base - print or set address offset
bdinfo - print Board Info structure
boot - boot default, i.e., run 'bootcmd'
bootd - boot default, i.e., run 'bootcmd'
bootm - boot application image from memory
bootp - boot image via network using BootP/TFTP protocol
cmp - memory compare
coninfo - print console devices and information
cp - memory copy
crc32 - checksum calculation
echo - echo args to console
erase - erase FLASH memory
flinfo - print FLASH memory information
go - start application at address 'addr'
help - print online help
httpsvr - Start HTTP server to load image
iminfo - print header information for application image
loadb - load binary file over serial line (kermit mode)
loop - infinite loop on address range
loopback - Ralink eth loopback test !!
md - memory display
mdio - Ralink PHY register R/W command !!
mm - memory modify (auto-incrementing)
mtest - simple RAM test
mw - memory write (fill)
nm - memory modify (constant address)
printenv- print environment variables
protect - enable or disable FLASH write protection
rarpboot- boot image via network using RARP/TFTP protocol
reset - Perform RESET of the CPU
run - run commands in an environment variable
saveenv - save environment variables to persistent storage
setenv - set environment variables
sleep - delay execution for some time
spicmd - read/write data from/to eeprom or vtss
tftpboot- boot image via network using TFTP protocol
version - print monitor version
RT3052 #