Posted: Wed Aug 08, 2012 2:26 Post subject: Not working :(
Thanks a lot for the firmwares. However, could anyone help me with my below dilemma ?
I had upgraded the router to DD-WRT with the July 4th release, after which the router was getting disconnected every few minutes and would not work until reset. I tried reuploading the July 4th firmware through both the emergency and normal system and it seemed to have uploaded it but I was still getting the same issue.
I have upgraded it to the July 20th release but the router is still dropping the connection (I can no longer connect to it via 192.168.1.1 ip which is the correct one)
Also, the original firmware from dlink is not available since the original firmware is the one the router had come with it.
At this point I am desperate and just want to solve this issue, I was trying to help a friend but now the router doesn't even work properly.
I'd appreciate any help you can give me. I could even brick the router completely to go and exchange it for a new one if there is no way to make this work.
Bricked it initially but that may have been my fault. After that I did the Dlink power off, press and hold reset, power on, continue holding reset for 12 seconds, and log in to 192.168.0.1 for the factory unbricking page, upload dd-wrt firmware, wait 5 mins, reboot, dd-wrt lives.
It was a little glitchy at first but then I did a factory default in dd-wrt and rebooted and all was good. Again... might have just been me.