Posted: Sun May 20, 2012 15:38 Post subject: La Fonera "Executing boot script"
Hi,
recently I tried to downgrade the DD-WRT on my Fonera 2100 but the downgrade failed.
If I power on my Fonera I just get the power LED going on and the ethernet LED blinking. I tried to telnet into the Router but I just get the following lines:
Code:
telnet 192.168.1.254 9000
Trying 192.168.1.254...
Connected to 192.168.1.254.
Escape character is '^]'.
== Executing boot script in 9.130 seconds - enter ^C to abort
Then nothing happens. I also can't abort with ^C.
I also tried a serial connection but the message I receive is almost the same:
Code:
+PHY ID is 0022:5521
Ethernet eth0: MAC address 00:18:84:26:ed:1c
IP: 192.168.1.254/255.255.255.0, Gateway: 0.0.0.0
Default server: 0.0.0.0
RedBoot(tm) bootstrap and debug environment [ROMRAM]
Non-certified release, version v1.3.0 - built 16:57:58, Aug 7 2006
Copyright (C) 2000, 2001, 2002, 2003, 2004 Red Hat, Inc.
Board: ap51
RAM: 0x80000000-0x81000000, [0x80040450-0x80fe1000] available
FLASH: 0xa8000000 - 0xa87f0000, 128 blocks of 0x00010000 bytes each.
== Executing boot script in 10.000 seconds - enter ^C to abort
Sometimes after a while I get this too:
Code:
RedBoot> fis load -l linux
too long file.
lzma_decode failed
