Posted: Mon Nov 26, 2018 14:58 Post subject: WR941ND v3.2 bricks when flashing v3
Hi!
Twice now I have tried flashing v3 build 37305.
In the router database this version should be supported by 3.x version routers. I did the 30/30/30 reset of the original firmware and then flashed factory-to-ddwrt via the web interface.
The result is a bootlooping router, that I have to unbrick via serial. No biggie, but I'd really like to get dd-wrt running on it again.
PS, I have bricked all of my routers at one point or another. Most of them have serial pins that I soldered on to them. I have only completely ruined (not recoverable) two routers, my WRT-400N and my 1043ND v1.8. My 400N should be recoverable via serial and TFTP, but I can't get the serial interface to work. The 1043ND just looks dead. _________________ Before asking a question on the forums, update dd-wrt: Where do I download firmware? I suggest reading it all.
QCA Best WiFi Settings
Some dd-wrt wiki pages are up to date, others are not. PM me if you find an old one.
Atheros:
Netgear R7800 x3 - WDS AP / station, gateway, QoS
TP-Link Archer C7 v2 x2 - WDS Station
TP-Link TL-WDR3600 v1 - WDS Station
TP-Link 841nd v8 - NU
D-Link 615 C1/E3/I1 x 7 - 1 WDS station
D-Link 825 B1 - NU
D-Link 862L A1 x2 - WDS Station
Netgear WNDR3700v2 - NU
UBNT loco M2 x2 - airOS
Broadcom
Linksys EA6400 - Gateway, QoS
Asus N66U - AP
Netgear WNDR3700v3 - not used
MediaTek
UBNT EdgeRouter X - switch
Joined: 12 May 2012 Posts: 66 Location: Rio Grande do Sul / Brasil
Posted: Tue Nov 27, 2018 22:13 Post subject: Re: WR941ND v3.2 bricks when flashing v3
ThingWizard wrote:
Hi!
Twice now I have tried flashing v3 build 37305.
In the router database this version should be supported by 3.x version routers. I did the 30/30/30 reset of the original firmware and then flashed factory-to-ddwrt via the web interface.
The result is a bootlooping router, that I have to unbrick via serial. No biggie, but I'd really like to get dd-wrt running on it again.