Posted: Sat Jul 14, 2012 8:19 Post subject: X86 configuration - please check and advise
Hello,
Please read the whole post. Thank You.
I'm new to this forum - X86 (I had Linksys WRT610Nv2 running DD-WRT Brainslayer build 2 years ago).
I have little knowledge on networks.
I build 2 machines:
1-st Alix 2d2 + Mikrotik R52Hn (Atheros 9220) to act as wireless bridge (My WISP is located 100m away). I have to connect WLAN to his access point (10.20.0.1) and pass the data throught LAN port. How to set this up as transparent bridge?
Is it possible to set up WAN port with static IP as management port? (to be connected to local network as 192.168.1.2)
2-nd Alix 2d2 + Mikrotik R52Hn (Atheros 9220) + Mikrotik R52H (Atheros 5414) will get data on WAN (10.20.0.83) and pass it to BR0 (192.168.1.1 - LAN + AP 2.4GHz + AP 5GHz)
What to change if I get static public IP?
Is this right image for me?:
Downloads › others › eko › BrainSlayer-V24-preSP2 › 2012 › 06-08-12-r19342 › x86 > dd-wrt_full_serial.image
or use the suggested X86 14896 build?
Please welcome any comments and suggestions.